[PCB_FORUM] Re: Help!!! Segment with same start and end points

If you are creating the artwork at a lower resolution than the board database, the round off can cause the ends of very short segments to end up at the same co-ordinate.

If you zoom way in at the specified point you might see the segment. If not, try unfilled lines. Or try using a window with the find filter while zooomed in. You might find 3 line segments where you expect to find 2.


--
Ron Dallas
Design Technology Group, Teradyne, Inc.
ph: 617-422-2585 fax: 617-422-2801
e-mail: ron.dallas@xxxxxxxxxxxx
-----------------------------------------------------------
To subscribe/unsubscribe: Send a message to icu-pcb-forum-request@xxxxxxxxxxxxx
with a subject of subscribe or unsubscribe

To view the archives of this list please login at
http://www.freelists.org. Our list name is icu-pcb-forum
or go to http://www.freelists.org/archives/icu-pcb-forum/

Problems or Questions:
        Send an email to icu-pcb-forum-admins@xxxxxxxxxxxxx

Want to post a job listing ? DON'T DO IT HERE! Better yet, join our jobs listing forum.

SUBSCRIBE:  icu-jobs-forum-subscribe@xxxxxxxxxx
POST:       icu-jobs-forum@xxxxxxxxxx
-----------------------------------------------------------

Other related posts: