[PCB_FORUM] Re: Help!!! Segment with same start and end points

Please run these allego scripts.This will show the danglings.validate the
dangling and delete.

regards
Selva
  -----Original Message-----
  From: Gerry Meier [mailto:gerry.meier@xxxxxxxxxxxxxx]
  Sent: Saturday, December 18, 2004 11:23 PM
  To: icu-pcb-forum@xxxxxxxxxxxxx
  Subject: [PCB_FORUM] Re: Help!!! Segment with same start and end points


  Van,

  When you run your summary report  or dangling line report are there
dangling lines?
  If so  "in a copy database" try glossing the dangling lines have "only"
line smoothing checked and "only" dangling lines inside line smoothing form
checked.

  Gerry

   Gerry Meier
  Sr. PCB Designer
  Freedom CAD Services, Inc.
  Voice: (603) 864-1300 x1350
  Alt. Voice: (386) 753-0048
  Email: gerry.meier@xxxxxxxxxxxxxx
  visit our website at<http://www.freedomcad.com







----------------------------------------------------------------------------
--
  From: Van Huynh (huynh) [mailto:huynh@xxxxxxxxx]
  Sent: Saturday, December 18, 2004 12:46 PM
  To: icu-pcb-forum@xxxxxxxxxxxxx
  Subject: [PCB_FORUM] Re: Help!!! Segment with same start and end points


  I ran DBDoctor within the database and outside on the shell command line
still doesn't help.
  Thanks for input

  Van Huynh






----------------------------------------------------------------------------
--
  From: Gerry Meier [mailto:gerry.meier@xxxxxxxxxxxxxx]
  Sent: Saturday, December 18, 2004 9:41 AM
  To: icu-pcb-forum@xxxxxxxxxxxxx
  Subject: [PCB_FORUM] Re: Help!!! Segment with same start and end points


  try running dbdoctor on the database

   Gerry Meier
  Sr. PCB Designer
  Freedom CAD Services, Inc.
  Voice: (603) 864-1300 x1350
  Alt. Voice: (386) 753-0048
  Email: gerry.meier@xxxxxxxxxxxxxx
  visit our website at<http://www.freedomcad.com







----------------------------------------------------------------------------
--
  From: Van Huynh (huynh) [mailto:huynh@xxxxxxxxx]
  Sent: Saturday, December 18, 2004 12:37 PM
  To: icu-pcb-forum@xxxxxxxxxxxxx
  Subject: [PCB_FORUM] Help!!! Segment with same start and end points


  I got a lots of these warning on every artwork layers,
  Any one know how to fix these errors message?

   WARNING: Segment with same start and end points at
   (75.2869 -194448.6314) will be ignored.  Increasing output
   accuracy may allow segment to be generated.


  My artwork parameter setup:

  DEVICE-TYPE           GERBER_RS274X
  OUTPUT-UNITS          INCHES
  FILM-SIZE             240000 160000
  FORMAT                2.5
  ABORT-ON-ERROR        NO
  SCALE                 1
  SUPPRESS-LEAD-ZEROES  YES
  SUPPRESS-TRAIL-ZEROES NO
  SUPPRESS-EQUAL        YES
  UNDEF-APT-CONT        NO

  NC Drill format is 2.5
  Drawing parameter accuracy is 4

  Thank you
  Van Huynh

Other related posts: