Hi folks.I can't get the sampling frequency to change on my Delta 1010LT for some reason.
Inside the M-audio Control Pannel, on the hardware tab, I see the word locked, and 44,100, but can't seem to do a simulated mouse click anywhere near them that accomplishes anything.
In Sonar's Audio Options, I try to change the default sampling rate from 44.1 to 96 KHz, but get an error that the sampling rate cannot be changed, and has been set to 44.1KHz 32-bit "as suggested by the driver".
So, do any of you have some precise instructions to share, when it comes to using the M-audio Control Pannel?
If I can figure out where to click, I can at least label graphics for future use.
thanks Chris PLEASE READ THIS FOOTER AT LEAST ONCE! To leave the list, click on the immediately following link: ddots-l-request@xxxxxxxxxxxxx?subject=unsubscribe If this link doesn't work then send a message to: ddots-l-request@xxxxxxxxxxxxx and in the Subject line type unsubscribeFor other list commands such as vacation mode, click on the immediately following link:
ddots-l-request@xxxxxxxxxxxxx?subject=faq orsend a message, to ddots-l-request@xxxxxxxxxxxxx
and in the Subject line type faq