Hi Steve!Thanks a lot for that! May I ask how you accessed the buttons to change sampling rate? I can find and mouse click the graphics immediately above and below the buffer size text to change that, but the same thing doesn't seem to work for sampling frequency.
At 05:30 PM 11/17/2013, you wrote:
Chris, if you use HSC, you can download my simple HSC set below. It just allows you to change sample rate and buffer size. https://dl.dropboxusercontent.com/u/14684704/M-AudioDeltaControlPanel.hsc Keystrokes: Control+Alt+H for the Hardware tab Control+alt+Equals to increase sample rate Control+Alt+dash to decrease sample rate Control+Equals to increase buffer size Control+Dash to decrease buffer size HTH, cheers Steve. Visit: www.vipaudioaccess.com for audio access solutions, articles, demos, to showcase your music and to basically get involved! -----Original Message----- From: ddots-l-bounce@xxxxxxxxxxxxx [mailto:ddots-l-bounce@xxxxxxxxxxxxx] On Behalf Of Chris Smart Sent: 17 November 2013 19:24 To: midimag@xxxxxxxxxxx Cc: ddots-l@xxxxxxxxxxxxx; audio-discuss@xxxxxxxxxxxxxxx Subject: [ddots-l] M-audio Delta 1010LT Sampling Rate Won't Change! Hi folks. I can't get the sampling frequency to change on my Delta 1010LT for some reason. Inside the M-audio Control Pannel, on the hardware tab, I see the word locked, and 44,100, but can't seem to do a simulated mouse click anywhere near them that accomplishes anything. In Sonar's Audio Options, I try to change the default sampling rate from 44.1 to 96 KHz, but get an error that the sampling rate cannot be changed, and has been set to 44.1KHz 32-bit "as suggested by the driver". So, do any of you have some precise instructions to share, when it comes to using the M-audio Control Pannel? If I can figure out where to click, I can at least label graphics for future use. thanks Chris PLEASE READ THIS FOOTER AT LEAST ONCE! To leave the list, click on the immediately following link: ddots-l-request@xxxxxxxxxxxxx?subject=unsubscribe If this link doesn't work then send a message to: ddots-l-request@xxxxxxxxxxxxx and in the Subject line type unsubscribe For other list commands such as vacation mode, click on the immediately following link: ddots-l-request@xxxxxxxxxxxxx?subject=faq or send a message, to ddots-l-request@xxxxxxxxxxxxx and in the Subject line type faq PLEASE READ THIS FOOTER AT LEAST ONCE! To leave the list, click on the immediately following link: ddots-l-request@xxxxxxxxxxxxx?subject=unsubscribe If this link doesn't work then send a message to: ddots-l-request@xxxxxxxxxxxxx and in the Subject line type unsubscribe For other list commands such as vacation mode, click on the immediately following link: ddots-l-request@xxxxxxxxxxxxx?subject=faq or send a message, to ddots-l-request@xxxxxxxxxxxxx and in the Subject line type faq
PLEASE READ THIS FOOTER AT LEAST ONCE! To leave the list, click on the immediately following link: ddots-l-request@xxxxxxxxxxxxx?subject=unsubscribe If this link doesn't work then send a message to: ddots-l-request@xxxxxxxxxxxxx and in the Subject line type unsubscribeFor other list commands such as vacation mode, click on the immediately following link:
ddots-l-request@xxxxxxxxxxxxx?subject=faq orsend a message, to ddots-l-request@xxxxxxxxxxxxx
and in the Subject line type faq