Hi Steve and Chris, do you think that this Set also works with the MAudio Profire 2626 soundcard pannel? I mean, does the MAudio control pannel interface is the same for all devices?
Thanks, Rui Vilarinho----- Original Message ----- From: "Steve Spamer" <steve@xxxxxxxxxxxxxxxxxx>
To: <ddots-l@xxxxxxxxxxxxx> Sent: Sunday, November 17, 2013 10:30 PM Subject: [ddots-l] Re: M-audio Delta 1010LT Sampling Rate Won't Change!
Chris, if you use HSC, you can download my simple HSC set below. It just allows you to change sample rate and buffer size. https://dl.dropboxusercontent.com/u/14684704/M-AudioDeltaControlPanel.hsc Keystrokes: Control+Alt+H for the Hardware tab Control+alt+Equals to increase sample rate Control+Alt+dash to decrease sample rate Control+Equals to increase buffer size Control+Dash to decrease buffer size HTH, cheers Steve. Visit: www.vipaudioaccess.comfor audio access solutions, articles, demos, to showcase your music and tobasically get involved! -----Original Message-----From: ddots-l-bounce@xxxxxxxxxxxxx [mailto:ddots-l-bounce@xxxxxxxxxxxxx] OnBehalf Of Chris Smart Sent: 17 November 2013 19:24 To: midimag@xxxxxxxxxxx Cc: ddots-l@xxxxxxxxxxxxx; audio-discuss@xxxxxxxxxxxxxxx Subject: [ddots-l] M-audio Delta 1010LT Sampling Rate Won't Change! Hi folks. I can't get the sampling frequency to change on my Delta 1010LT for some reason. Inside the M-audio Control Pannel, on the hardware tab, I see the word locked, and 44,100, but can't seem to do a simulated mouse click anywhere near them that accomplishes anything. In Sonar's Audio Options, I try to change the default sampling rate from 44.1 to 96 KHz, but get an error that the sampling rate cannot be changed, and has been set to 44.1KHz 32-bit "as suggested by the driver".So, do any of you have some precise instructions to share, when it comes tousing the M-audio Control Pannel?If I can figure out where to click, I can at least label graphics for futureuse. thanks Chris PLEASE READ THIS FOOTER AT LEAST ONCE! To leave the list, click on the immediately following link: ddots-l-request@xxxxxxxxxxxxx?subject=unsubscribe If this link doesn't work then send a message to: ddots-l-request@xxxxxxxxxxxxx and in the Subject line type unsubscribe For other list commands such as vacation mode, click on the immediately following link: ddots-l-request@xxxxxxxxxxxxx?subject=faq or send a message, to ddots-l-request@xxxxxxxxxxxxx and in the Subject line type faq PLEASE READ THIS FOOTER AT LEAST ONCE! To leave the list, click on the immediately following link: ddots-l-request@xxxxxxxxxxxxx?subject=unsubscribe If this link doesn't work then send a message to: ddots-l-request@xxxxxxxxxxxxx and in the Subject line type unsubscribe For other list commands such as vacation mode, click on the immediately following link: ddots-l-request@xxxxxxxxxxxxx?subject=faq or send a message, to ddots-l-request@xxxxxxxxxxxxx and in the Subject line type faq
PLEASE READ THIS FOOTER AT LEAST ONCE! To leave the list, click on the immediately following link: ddots-l-request@xxxxxxxxxxxxx?subject=unsubscribe If this link doesn't work then send a message to: ddots-l-request@xxxxxxxxxxxxx and in the Subject line type unsubscribeFor other list commands such as vacation mode, click on the immediately following link:
ddots-l-request@xxxxxxxxxxxxx?subject=faq orsend a message, to ddots-l-request@xxxxxxxxxxxxx
and in the Subject line type faq