Chris, if you use HSC, you can download my simple HSC set below. It just allows you to change sample rate and buffer size. https://dl.dropboxusercontent.com/u/14684704/M-AudioDeltaControlPanel.hsc Keystrokes: Control+Alt+H for the Hardware tab Control+alt+Equals to increase sample rate Control+Alt+dash to decrease sample rate Control+Equals to increase buffer size Control+Dash to decrease buffer size HTH, cheers Steve. Visit: www.vipaudioaccess.com for audio access solutions, articles, demos, to showcase your music and to basically get involved! -----Original Message----- From: ddots-l-bounce@xxxxxxxxxxxxx [mailto:ddots-l-bounce@xxxxxxxxxxxxx] On Behalf Of Chris Smart Sent: 17 November 2013 19:24 To: midimag@xxxxxxxxxxx Cc: ddots-l@xxxxxxxxxxxxx; audio-discuss@xxxxxxxxxxxxxxx Subject: [ddots-l] M-audio Delta 1010LT Sampling Rate Won't Change! Hi folks. I can't get the sampling frequency to change on my Delta 1010LT for some reason. Inside the M-audio Control Pannel, on the hardware tab, I see the word locked, and 44,100, but can't seem to do a simulated mouse click anywhere near them that accomplishes anything. In Sonar's Audio Options, I try to change the default sampling rate from 44.1 to 96 KHz, but get an error that the sampling rate cannot be changed, and has been set to 44.1KHz 32-bit "as suggested by the driver". So, do any of you have some precise instructions to share, when it comes to using the M-audio Control Pannel? If I can figure out where to click, I can at least label graphics for future use. thanks Chris PLEASE READ THIS FOOTER AT LEAST ONCE! To leave the list, click on the immediately following link: ddots-l-request@xxxxxxxxxxxxx?subject=unsubscribe If this link doesn't work then send a message to: ddots-l-request@xxxxxxxxxxxxx and in the Subject line type unsubscribe For other list commands such as vacation mode, click on the immediately following link: ddots-l-request@xxxxxxxxxxxxx?subject=faq or send a message, to ddots-l-request@xxxxxxxxxxxxx and in the Subject line type faq PLEASE READ THIS FOOTER AT LEAST ONCE! To leave the list, click on the immediately following link: ddots-l-request@xxxxxxxxxxxxx?subject=unsubscribe If this link doesn't work then send a message to: ddots-l-request@xxxxxxxxxxxxx and in the Subject line type unsubscribe For other list commands such as vacation mode, click on the immediately following link: ddots-l-request@xxxxxxxxxxxxx?subject=faq or send a message, to ddots-l-request@xxxxxxxxxxxxx and in the Subject line type faq