Hi, Paul, Thanks for your explanation. That was very helpful and clear. The problem was just that: I had all outputs routed to wave device, not to monitor mixer. When I set outputs 1/2 to monitor mixer and opened all volume controls there, then the system worked just like I want. I have worked with physical mixers before. So, it was quite easy to realize how does it work - after You explained it! Thanks! Btw... How do you access all controls in the mixer? How do you know where you are? My jaws says only "Mixer inputs" everywhere. I have noticed up/down sliders are volume controls and left/right sliders are pan controls. First, I turned all controls to 100% and then wondered why I get signal only far right. Do You know something about the Bass management page? Johanna -- Johanna Herranen johanna.herranen@xxxxxxxxxxx Kemiankatu 1 C 17 Skype: jherranen 33720 Tampere irc: lulu- ** To leave the list, click on the immediately-following link:- ** [mailto:ddots-l-request@xxxxxxxxxxxxx?subject=unsubscribe] ** If this link doesn't work then send a message to: ** ddots-l-request@xxxxxxxxxxxxx ** and in the Subject line type ** unsubscribe ** For other list commands such as vacation mode, click on the ** immediately-following link:- ** [mailto:ddots-l-request@xxxxxxxxxxxxx?subject=faq] ** or send a message, to ** ddots-l-request@xxxxxxxxxxxxx with the Subject:- faq