Thanks a lot Robert for your so quick response.:) Though I have googled quite a bit about virtual audio driver but I have not gone through any document or link so far because I was not sure from where to start. Surely I will look into the link given by you. On Wed, May 4, 2011 at 10:45 AM, Robert Bielik <robert.bielik@xxxxxxxxxx>wrote: > Sarbojit Sarkar skrev 2011-05-04 07:02: > > My actual question was "which one *ac3 , pcmex or.....* I need to choose >> inside MSVAD folder for my current requirement. And I did not see any thread >> is describing this :(. >> May be I am asking this because of less knowledge in audio driver >> architecture. But it will be great if you can tell me or give some link/docs >> where each of these folders are explained in details. >> > > Yes, for below Vista you need something like the MSVAD. I'd go with the > "Simple" MSVAD, as it does allow you to create what you want (albeit with > quite some additional effort over what's available in the DDK, and > unfortunately I know of no public source for it). > > Have you considered going with read-to-go alternatives, such as Virtual > Audio Cable (http://software.muzychenko.net/eng/vac.htm) ? > > > Regards, > /Rob > ****************** > > WDMAUDIODEV addresses: > Post message: mailto:wdmaudiodev@xxxxxxxxxxxxx > Subscribe: mailto:wdmaudiodev-request@xxxxxxxxxxxxx?subject=subscribe > Unsubscribe: mailto:wdmaudiodev-request@xxxxxxxxxxxxx?subject=unsubscribe > Moderator: mailto:wdmaudiodev-moderators@xxxxxxxxxxxxx > > URL to WDMAUDIODEV page: > http://www.wdmaudiodev.com/ > >