You can actually disassemble the blue crt and dry out the gasket and gasket-socket and apply a little silicone RTV to the socket-hole and gasket and reassemble it. Get some coolant and fill a plastic squeeze bottle and refill the crt. Take the board out of the set and run it through a dishwasher. Let the dishwasher dry out the board for about 15 -30 minutes, then open it and let it air-dry.. Don't forget to use dishwasher detergent, plain water will not deep clean like the detergent does. Damon Brunger Telrad Electronics Fort Wayne IN ----- Original Message ----- From: "Mehdi Tafaghodi" <mehdi@xxxxxxxxxx> To: <techassist@xxxxxxxxxxxxx> Sent: Thursday, April 14, 2005 11:57 AM Subject: [TechAssist] Mitsubishi VS-60703 > Hi everyone > > customer complain on this mitsubishi vs-60703 was that tv used to stay > on all the time and could not turn it off and now it is dead . I first > suspected power botton on control board or relay stock.Both checked > ok. Then I saw a leak on the board under left picture tube ( when > looking from back . Now customer wants to fix this tv even if it needs > new picture tube. Should I go ahead and order the picture tube ? Any > comments ? > > Mehdi > Nova Service Center > 7531 Lindbergh Dr. > Gaithersburg, MD 20879 > 240-632-1717 > mehdi@xxxxxxxxxx > > > -------------------------------------------------------------------------- --- > This Email List is Public. Remove: http://www.tech-assist.org/remove.htm > Lost Password: http://www.tech-assist.org and select "Login Problems?". > Email Archives: //www.freelists.org/archives/techassist/ > > > > -- > Internal Virus Database is out-of-date. > Checked by AVG Anti-Virus. > Version: 7.0.308 / Virus Database: 266.8.0 - Release Date: 3/21/2005 > > ----------------------------------------------------------------------------- This Email List is Public. Remove: http://www.tech-assist.org/remove.htm Lost Password: http://www.tech-assist.org and select "Login Problems?". Email Archives: //www.freelists.org/archives/techassist/