That is correct on the Baltic birch. But see my post about the panel on the driver's side. ________________________________ From: Gary <garypalexander@xxxxxxxxx> To: "tcb@xxxxxxxxxxxxx" <tcb@xxxxxxxxxxxxx> Cc: "tcb@xxxxxxxxxxxxx" <tcb@xxxxxxxxxxxxx> Sent: Tuesday, February 18, 2014 8:21 AM Subject: [tcb] Re: Westy Wood Panels - Free Original Westfalia paneling is 1/8" Baltic birch You need to get 5'x5' pieces available at fine woods in Austin Around $20-25 a sheet Good luck On Feb 18, 2014, at 8:07 AM, shirley hall <vwbuslady@xxxxxxxxxxxxx> wrote: > > > Sammie, I used 1/8 to replace cargo Dior wood. It is too thick. It stick out > above the molded area. Thought I was told it was suppose to be thinner wood. > > > ------------------------------ > On Mon, Feb 17, 2014 10:06 PM CST sammie smith wrote: > >> Shirley: I have done several of them from 5X5 sheets of birch veneer that >> the cabinet builders use and I sure thought it was 1/8th. Still have some >> scraps laying around as well as the panels on the bus. Next time I get a >> chance I will measure their thickness. Most good lumberyards/building >> supply places carry the birch in 5X5 sheets. Unfortunately that does not >> work for the side panel on the driver's side since it is longer than 5'. >> You can splice it under the area of the table and it is not too noticeable; >> or you can use a 4X8 sheet and then the grain runs the wrong way. >> >> >> ________________________________ >> From: shirley hall <vwbuslady@xxxxxxxxxxxxx> >> To: tcb@xxxxxxxxxxxxx >> Sent: Monday, February 17, 2014 9:14 PM >> Subject: [tcb] Re: Westy Wood Panels - Free >> >> >> >> the panels on the cargo doors gor 65 westy . Tried 1/8 but too thick. >> Believe from home depot, birch panels but 1/8 not 1/16. Looking for >> shop/store that has 1/16? >> Local? >> >> ------------------------------ >> On Mon, Feb 17, 2014 9:03 PM CST shirley hall wrote: >> >>> >>> >>> I thought panels were 1/ 16? Tried 1/8 and didn't quite fit right metal >>> guides for panels?? >>> >>> >>> ------------------------------ >>> On Mon, Feb 17, 2014 10:21 AM CST theresabuckner@xxxxxxx wrote: >>> >>> >>> Ronnie I have paneling that needs to be cut . I have everything but the >>> roof . Not sure it would be worth the mess, to haul to & from NAC ? Is the >>> ceiling not square ? & how many pieces ? I have 1/8 " panels 4x8 Terry R >>> >>> >>> -----Original Message----- >>> From: Ronnie Hughes <fracdogii@xxxxxxxxx> >>> To: Tcb <tcb@xxxxxxxxxxxxx> >>> Sent: Mon, Feb 17, 2014 5:01 am >>> Subject: [tcb] Westy Wood Panels - Free >>> >>> >>> >>> I'm replacing all of the wood panels and floor in the back of my Westy and >>> wondered if anyone wants the old ones for patterns? I can bring them to >>> Galveston or Nac next month otherwise I'm throwing them away. >>> >>> >>> 3 are okay, 3 are poor, floor is poor, but all are good enough to use as >>> patterns. Ceiling too. >>> >>> >>> Ronnie >>> >>> >>> >>> >>> >>> >>> >>> >>> >>> >>> >>> >