Here are some instructions for blade brazing using an electric device for the heat source. The information concerning blade preparation and finishing should be the same for torch as for electric. http://www.owwm.com/files/PDF/Oliver/562-ElecBrazer.pdf Charles -------------- Original message -------------- From: "Eric Walker" <eric@xxxxxxxxxxxxxxxxxxxxxxxxxx> > Wilfrried, Do you chamfer the ends of the blade before silver soldering ? > I've tried a few times when short of a blade but without much success. > > E.W. MODEL ENGINEERING DISCUSSION LIST. To UNSUBSCRIBE from this list, send a blank email to, modeleng-request@xxxxxxxxxxxxx with the word "unsubscribe" in the subject line.