[modeleng] Re: Taper Turning Attachment
- From: "Shep" <shep.28@xxxxxxxxxxxx>
- To: <modeleng@xxxxxxxxxxxxx>
- Date: Tue, 8 Apr 2008 16:37:03 +0100
I have seen an article suggesting an adaptation of the Attachment for use as
a sine bar, in which case, slip guages could be used to accurately determine
the taper.
Cheers
Hubert
----- Original Message -----
From: "Ken Strauss" <ken.strauss@xxxxxxxxxxxx>
To: <modeleng@xxxxxxxxxxxxx>
Sent: Tuesday, April 08, 2008 2:09 PM
Subject: [modeleng] Re: Taper Turning Attachment
> Permanently mounting one of the cheap 1" travel dial indicators on the
> taper
> mechanism would seem to be a good way to set the taper. The screws would
> still be nice to allow fine adjustment but they wouldn't need scales.
>
MODEL ENGINEERING DISCUSSION LIST.
To UNSUBSCRIBE from this list, send a blank email to,
modeleng-request@xxxxxxxxxxxxx with the word "unsubscribe" in the subject line.
Other related posts:
