Thanks for your good advice, Jerry. Cheers! Hubert ----- Original Message ----- From: "Jerry Kimberlin" <kimberln@xxxxxxxxxxx> To: <modeleng@xxxxxxxxxxxxx> Sent: Monday, April 07, 2008 12:19 AM Subject: [modeleng] Re: Taper Turning Attachment > Shep wrote: > >> I am slightly puzzled by the mechanism, which has two slides, the lower >> one parallel to the bed, and the upper one, with the normal facility for >> setting to an angle. All previous versions I have encountered do not >> have the lower slide. Any old South Bend operators remember the purpose >> of this lower slide? > > It's been too long since I've seen one. However, if you want to go > over to Yahoogroups, there is a South Bend group. All the manuals and > parts diagrams should be there in the files. > > JerryK > MODEL ENGINEERING DISCUSSION LIST. > > To UNSUBSCRIBE from this list, send a blank email to, > modeleng-request@xxxxxxxxxxxxx with the word "unsubscribe" in the subject > line. MODEL ENGINEERING DISCUSSION LIST. To UNSUBSCRIBE from this list, send a blank email to, modeleng-request@xxxxxxxxxxxxx with the word "unsubscribe" in the subject line.