MessageHi Caroline, The embosser is set to 40 characters per line still, so it prints page two starting at the 40th character position of side one. Here's how to fix it: Press the OL key, Enter 0.1E, Enter 14.30E, Enter 1.1E. That will set the embosser to 30 character per line and should fix your problem. Just remember to reset to 14.40E using the same commands above when you return to using 11" wide paper. Best Regards, Mark ----- Original Message ----- From: Caroline Congdon To: duxuser@xxxxxxxxxxxxx Sent: Monday, September 13, 2004 3:36 PM Subject: [duxuser] Embossing with 10.5 and a Versa-Point Duo Hi all. Today is the first time I've needed to emboss since installing 10.5 a couple of weeks back. I'm running into a problem. I set up the paper as narrow 11/inch, told the global embosser settings to default to a line of 30 characters, and 25 lines per page. Interpoint is also checked. The front page prints great, but even pages are most definitely not correct. It's printing the last 25 characters on each line, and the first couple of characters are showing up on the perforation. What am I not seeing here? Thanks in advance for any suggestions. Caroline Caroline Congdon; Milwaukee, Wisconsin mailto:carolinecongdon@xxxxxxxxxxxxx Web Site: http://home.earthlink.net/~carolinecongdon/ AOL IM: carolinecongdon@xxxxxxxxxxxxx Yahoo IM: kb9qqz MSN IM: carolinecongdon@xxxxxxxxxxx