I have problem with i1pro on w7x64 to read charts.
Im sure that cable and i1 is ok. (On older pc with XP that hardware works
fine.)
Im even thy on fresh windows install, without any other calibration software
just argyll and dispicalGUI
If it matters the pc is i2500k +p67 chipset all drivers are up to date.
Any ideas for solution?..
Microsoft Windows [Version 6.1.7600]
Copyright (c) 2009 Microsoft Corporation. All rights reserved.
C:\Users\MARCIN>chartread PrinterA
Place the instrument on its reflective white reference Serial no. xxxxxx,
and then hit any key to continue,
or hit Esc or Q to abort:
Calibration complete
Ready to read strip pass A
Press 'f' to move forward, 'b' to move back, 'n' for next unread,
'd' when done, Esc or 'q' to quit without saving.
Trigger instrument switch or any other key to start:
Strip read OK (Strip read in reverse direction)
Ready to read strip pass B
Press 'f' to move forward, 'b' to move back, 'n' for next unread,
'd' when done, Esc or 'q' to quit without saving.
Trigger instrument switch or any other key to start:
Strip read failed due to communication problem.
Hit Esc or 'q' to give up, any other key to retry:
*>>>>>>>>>>>>no internal light while scanning
*
Ready to read strip pass B
Press 'f' to move forward, 'b' to move back, 'n' for next unread,
'd' when done, Esc or 'q' to quit without saving.
Trigger instrument switch or any other key to start:
Strip read failed due to communication problem.
Hit Esc or 'q' to give up, any other key to retry:
--
Pozdrawiam
Marcin
Attachment:
2011-07-04_201536.png
Description: PNG image
