Besides the 230 to 300 volt supply to the ballast look for a start pulse from micro usually around 3-5 volts. Most "Training manuals" will tell where to test for this pulse, on some models you may need to contact manufacturer tech line. Robert tvservice@xxxxxxxxxxxxx H & H Electronics Inc ----- Original Message ----- From: "Damon" <damon101@xxxxxxxxxxxxxx> To: <techassist@xxxxxxxxxxxxx> Sent: Tuesday, August 10, 2004 7:57 AM Subject: [TechAssist] Re: Question on Hitachi 50v500a > Well so far the only test I know is to check for 230V dc on the main line > going into the ballast, I'd like to check the transformer area with a probe > and see if inductive pickup works on these transformers, just like we do > with IHVT's......right now, if I don't hear diddly coming from the ballast, > either within one minute of the fans coming on in the LCDs or within 20 > seconds of the color wheel spinning up on the DLPs, then I suspect the > ballast blown....of course you have to have a quiet room for this... > > Damon Brunger > Telrad Electronic Services > Ft Wayne, IN 46815 > ----- Original Message ----- > From: "Leonard Caillouet" <lcaillo@xxxxxxxxxxxx> > To: <techassist@xxxxxxxxxxxxx> > Sent: Tuesday, August 10, 2004 7:06 AM > Subject: [TechAssist] Re: Question on Hitachi 50v500a > > > | Most of the ballasts that we have seen that were bad were on Sharp > | projectors. They would cause the lamp to fail early or, as Damon said, > not > | fire at all. Too bad most of the parts are not available on those. They > | would not be very hard to repair. I know I could use some better > | troubleshooting and testing techniques for them. What are the rest of you > | doing? If we had a good procedure for testing the ballast, this is one > | service that we could offer to discourage customers from changing the > lamps > | themselves. A ballasts test, cleaning, and calibration with each lamp > | change could be a good service package to offer. > | > | Lemonade from lemons...or margaritas from limes, depending on the number > of > | dogs in the shop... > | > | Leonard Caillouet > | Electronics World > | > | ----- Original Message ----- > | From: "Damon" <damon101@xxxxxxxxxxxxxx> > | To: <techassist@xxxxxxxxxxxxx> > | Sent: Monday, August 09, 2004 10:33 PM > | Subject: [TechAssist] Re: Question on Hitachi 50v500a > | > | > | > Mostly bulbs, no ballasts. When you get there, listen closely to the > | ballast > | > while it's firing.....bad bulb will tic tic tic......tic tic > tic.....I've > | > had some where the ballast will cause the bulb to rattle like a thin > piece > | > of sheet metal, ballast is good, but the bulb has lost the gas if you > hear > | > that. > | > > | > Damon Brunger > | > Telrad Electronic Services > | > Ft Wayne, IN 46815 > | > ----- Original Message ----- > | > From: <Royal19960@xxxxxxx> > | > To: <techassist@xxxxxxxxxxxxx>; <gizmo@xxxxxxxxxxxxxxxx> > | > Sent: Monday, August 09, 2004 2:33 PM > | > Subject: [TechAssist] Question on Hitachi 50v500a > | > > | > > | > | Hi. > | > | I have a service call to do on one of these and it's quite a few milws > | > away. > | > | The"red" led stays on all the time and the "laml" led lights. > | > | Hitachi says I should go out there (60 miles round trip) and see if > the > | > relay > | > | clicks with the back off, then drive back and order the bulb and then > | > return > | > | to the home and install it. > | > | The question,,,,,Have you had any bad ballest's or is it always the > | buld? > | > | Thanks > | > | Roy > | > | > | > | Roy E. Adams C.E.T./C.A. > | > | Bonded TV Service > | > | 5158 W Forest Home Ave > | > | Milwaukee, WI 53219 > | > | 414-541-9111 > | > | Bondedtv.com > | > | We have over 8,000 tubes listed on the website > | > | Web hosting at only $50.00 per year at BondedHost.com > | > | > | > | > | > | > | > > | > | -------------------------------------------------------------------------- > | > --- > | > | Lost Password: > | > | http://www.tech-assist.org and select "Login Problems?". > | > | Email Archives: > | > | //www.freelists.org/archives/techassist/ > | > | > | > > | > > | > > -------------------------------------------------------------------------- > | --- > | > Lost Password: > | > http://www.tech-assist.org and select "Login Problems?". > | > Email Archives: > | > //www.freelists.org/archives/techassist/ > | > | > | -------------------------------------------------------------------------- > --- > | Lost Password: > | http://www.tech-assist.org and select "Login Problems?". > | Email Archives: > | //www.freelists.org/archives/techassist/ > | > | > > > -------------------------------------------------------------------------- --- > Lost Password: > http://www.tech-assist.org and select "Login Problems?". > Email Archives: > //www.freelists.org/archives/techassist/ ----------------------------------------------------------------------------- Lost Password: http://www.tech-assist.org and select "Login Problems?". Email Archives: //www.freelists.org/archives/techassist/