Ooooookay. Did the sensor test again (with a weekend rested mind) and micro still comes up as sensor failure. Can the sensor be installed backwords. I see it has a line/arrow that might deliniate a direction that it should be installed, but the schematics provided do not give a clue if this possible. I checked the sensor heater, and it reads 30 ohms---right on. thanks for any ideas. I am still leaning towards the control panel. Jeff Farnsworth Lyles TV and Appliance 17 S Washington St Elkhorn, Wi. 53121 ph 262-723-3477 fax 262-723-3658 tech@xxxxxxxxxxx ----- Original Message ----- From: "Hivolts" <hivolts@xxxxxxxxxxxxxxxx> To: <techassist@xxxxxxxxxxxxx> Sent: Saturday, September 21, 2002 7:07 PM Subject: [TechAssist] Re: GE OTR micro EMO3000 CCC sensor cook problem > > Jeff > I had one just like it but it was the senor.check and see if the wiring > harness is rubbing anywhere.and make sure that the plug on the smart board > is soldered.I have seen them look good but be bad.I'll write out the 2 step > again so u can understand them this them with out all the crap lol . > (1) to check the senor on the key pad push 7 and 8 at the same time.u should > have a number between 15 and 185.and if it 14 or 186 u have a bad senor. > (2) put in 1/3 cup of water and hit popcorn.let it run when it is almost > done 20 sec should popup in the time window let it run down to off.hit 7 and > 8 again at the same time and see if the number that is there is 75% of the > first number( I E) if the number was 10 then it should show at least 7.5.it > should be very close. > hope this helps if not I get back in my little bag of tricks.let me know ok > chuck > ----- Original Message ----- > From: "Lyles Tv" <tech@xxxxxxxxxxx> > To: <techassist@xxxxxxxxxxxxx> > Sent: Saturday, September 21, 2002 1:10 PM > Subject: [TechAssist] Re: GE OTR micro EMO3000 CCC sensor cook problem > > > > > > And back to the original problem--I did the test that you sent (somewhat > > garbled but useable) It ran for a while, the stopped and said "sensor > > error" I pressed 7 and 8 and the number was approximatly 75% of the first > > number. Any other thoughts? TIA > > Jeff Farnsworth > > Lyles TV and Appliance > > 17 S Washington St > > Elkhorn, Wi. 53121 > > ph 262-723-3477 > > fax 262-723-3658 > > tech@xxxxxxxxxxx > > ----- Original Message ----- > > From: "Gary McCartney" <number63@xxxxxxxxxxxxx> > > To: <techassist@xxxxxxxxxxxxx> > > Sent: Saturday, September 21, 2002 11:47 AM > > Subject: [TechAssist] Re: GE OTR micro EMO3000 CCC sensor cook problem > > > > > > > > > > Maybe its possible that you can set each email address you send to, in > > > either HTML or plain text format. I'm guessing that you have Tech Assist > > > set to HTML and all other addresses set to plain text. If Outlook > > > doesn't have this feature, then chalk one up for netscape 7. > > > > > > > > > > > > > > > > > > > > > Gary McCartney > > > > > > McCartney Electronics > > > 7134 Fife Rd, RR 7 > > > Guelph Ontario Canada N1H 6J4 > > > Fax: (519)821-1530 > > > email: number63 (at) inetsonic.com > > > > > > > > > > > > > > > > > > > > > Hivolts wrote: > > > > > > > > Damon > > > > I have all ready did that.and this is the only site that this > happens.I > > did > > > > reload my outlook express and see if it has some thing to do with > that. > > I > > > > have tried everything else > > > > chuck > > > > ----- Original Message ----- > > > > From: "Damon" <DAMON101@xxxxxxxxxxxxxx> > > > > To: <techassist@xxxxxxxxxxxxx> > > > > Sent: Saturday, September 21, 2002 8:12 AM > > > > Subject: [TechAssist] Re: GE OTR micro EMO3000 CCC sensor cook problem > > > > > > > > > > > > > > This is what happens when your replies are sent in HTML format, the > > > > > extra-goofy stuff is the encoding. He needs to set his formatting to > > Plain > > > > > Text instead of HTML (or Rich Text). > > > > > > > > > > ----- Original Message ----- > > > > > From: "Ed Gaidies" <teltek2@xxxxxxxxxxxx> > > > > > To: "TechAssist" <techassist@xxxxxxxxxxxxx> > > > > > Sent: Friday, September 20, 2002 7:34 PM > > > > > Subject: [TechAssist] Re: GE OTR micro EMO3000 CCC sensor cook > problem > > > > > > > > > > > > > > > > > > > > > > Does anyone know what the "h*ll" this guy is sending. > > > > > > I'm receiving this on a "mac". > > > > > > This is not even an "AOL" member. > > > > > > > > > > > > -Ed- > > > > > > > > > > > > Hivolts The above is the reply to your message dated 9/20/02 > > 7:33 PM > > > > > > > > > > > > > Content-Type: Text/Plain; > > > > > > > charset="iso-8859-1" > > > > > > > Content-Transfer-Encoding: quoted-printable > > > > > > > > > > > > > > Jeff=0D > > > > > > > if u got the replay i sent and it messed up let me know.I > thought > > I > > > > had > > > > > i= > > > > > > > t > > > > > > > fixed.If u need it I'll resend on how to check the senor.=0D > > > > > > > sorry =0D > > > > > > > chuck=0D > > > > > > > staples TV=0D > > > > > > > =0D > > > > > > > -------Original Message-------=0D > > > > > > > =0D > > > > > > > From: techassist@xxxxxxxxxxxxx=0D > > > > > > > Date: Friday, September 20, 2002 12:38:04 PM=0D > > > > > > > To: techassist@xxxxxxxxxxxxx=0D > > > > > > > Subject: [TechAssist] GE OTR micro EMO3000 CCC sensor cook > > problem=0D > > > > > > > =0D > > > > > > > =0D > > > > > > > Jeff Farnsworth=0D > > > > > > > Ge OTR micro Model EMO3000 CCC Made 4/01=0D > > > > > > > I was handed this as a problem child, so bear with me. =0D > > > > > > > Would sensor cook the first bag of popcorn, and then would not > > cook > > > > the > > > > > > > second bag fully. Previous tech replaced the sensor per ge tech > > > > assist. > > > > > > > Still has same problem. Before I replace the control board, has > > > > someone > > > > > > > found a cure for this somewhat odd symptom?=0D > > > > > > > =0D > > > > > > > =0D > > > > > > > =0D > > > > > > > Lyles TV and Appliance=0D > > > > > > > 17 S Washington St=0D > > > > > > > Elkhorn, Wi. 53121=0D > > > > > > > ph 262-723-3477=0D > > > > > > > fax 262-723-3658=0D > > > > > > > tech@xxxxxxxxxxx=0D > > > > > > > =0D > > > > > > > =0D > > > > > > > ------------------------------------------=0D > > > > > > > To REMOVE your email address, click here:=0D > > > > > > > http://www.tech-assist.org/unsubb.html=0D > > > > > > > To CHANGE your email address, click here:=0D > > > > > > > http://www.techassist.net/forms/change.html=0D > > > > > > > ------------------------------------------=0D > > > > > > > ***NEW*** Tips Added Instantly!!!***=0D > > > > > > > Submit Repair Tips here: =0D > > > > > > > http://www.tech-assist.org/secure/tip/=0D > > > > > > > =0D > > > > > > > =2E > > > > > > > > > > > > > > > > > > > > > > > > > > > > ------------------------------------------ > > > > > > > To REMOVE your email address, click here: > > > > > > > http://www.tech-assist.org/unsubb.html > > > > > > > To CHANGE your email address, click here: > > > > > > > http://www.techassist.net/forms/change.html > > > > > > > ------------------------------------------ > > > > > > > ***NEW*** Tips Added Instantly!!!*** > > > > > > > Submit Repair Tips here: > > > > > > > http://www.tech-assist.org/secure/tip/ > > > > > > > > > > > > ------------------------------------------ > > > > > > To REMOVE your email address, click here: > > > > > > http://www.tech-assist.org/unsubb.html > > > > > > To CHANGE your email address, click here: > > > > > > http://www.techassist.net/forms/change.html > > > > > > ------------------------------------------ > > > > > > ***NEW*** Tips Added Instantly!!!*** > > > > > > Submit Repair Tips here: > > > > > > http://www.tech-assist.org/secure/tip/ > > > > > > > > > > > > > > > > ------------------------------------------ > > > > > To REMOVE your email address, click here: > > > > > http://www.tech-assist.org/unsubb.html > > > > > To CHANGE your email address, click here: > > > > > http://www.techassist.net/forms/change.html > > > > > ------------------------------------------ > > > > > ***NEW*** Tips Added Instantly!!!*** > > > > > Submit Repair Tips here: > > > > > http://www.tech-assist.org/secure/tip/ > > > > > > > > > > > > > > > > > > ------------------------------------------ > > > > To REMOVE your email address, click here: > > > > http://www.tech-assist.org/unsubb.html > > > > To CHANGE your email address, click here: > > > > http://www.techassist.net/forms/change.html > > > > ------------------------------------------ > > > > ***NEW*** Tips Added Instantly!!!*** > > > > Submit Repair Tips here: > > > > http://www.tech-assist.org/secure/tip/ > > > > > > -- > > > > > > > > > > > > Gary McCartney > > > > > > McCartney Electronics > > > 7134 Fife Rd, RR 7 > > > Guelph Ontario Canada N1H 6J4 > > > Fax: (519)821-1530 > > > email: number63 (at) inetsonic.com > > > > > > ------------------------------------------ > > > To REMOVE your email address, click here: > > > http://www.tech-assist.org/unsubb.html > > > To CHANGE your email address, click here: > > > http://www.techassist.net/forms/change.html > > > ------------------------------------------ > > > ***NEW*** Tips Added Instantly!!!*** > > > Submit Repair Tips here: > > > http://www.tech-assist.org/secure/tip/ > > > > > > > > > > ------------------------------------------ > > To REMOVE your email address, click here: > > http://www.tech-assist.org/unsubb.html > > To CHANGE your email address, click here: > > http://www.techassist.net/forms/change.html > > ------------------------------------------ > > ***NEW*** Tips Added Instantly!!!*** > > Submit Repair Tips here: > > http://www.tech-assist.org/secure/tip/ > > > > > > > ------------------------------------------ > To REMOVE your email address, click here: > http://www.tech-assist.org/unsubb.html > To CHANGE your email address, click here: > http://www.techassist.net/forms/change.html > ------------------------------------------ > ***NEW*** Tips Added Instantly!!!*** > Submit Repair Tips here: > http://www.tech-assist.org/secure/tip/ > ------------------------------------------ To REMOVE your email address, click here: http://www.tech-assist.org/unsubb.html To CHANGE your email address, click here: http://www.techassist.net/forms/change.html ------------------------------------------ ***NEW*** Tips Added Instantly!!!*** Submit Repair Tips here: http://www.tech-assist.org/secure/tip/