Thanks Bill.. It worked.. Dominic -----Original Message----- From: overture-bounce@xxxxxxxxxxxxx [mailto:overture-bounce@xxxxxxxxxxxxx] On Behalf Of Bill Henshaw Sent: Thursday, January 31, 2008 4:28 AM To: overture@xxxxxxxxxxxxx Subject: [overture] Re: Hyberbolic grid generation without Ogen Hi Dominic You might want to use a DataPointMapping for then you can change the individual grid points. ...Bill #DOMINIC DENVER JOHN CHANDAR# wrote: > Hi Bill, > > Thanks a lot. It worked fine. I'm now trying to modfiy the surface > grid points based on the originial airfoil profile. I call the > NurbsMapping class to create a new surface from the existing vertices > (as in the code I had attached previously). But when I pass this > surface as the "initial surface" to the hyperbolic grid generator, it > throws the same error...Also Is it possible to modify the vertex > information from AirfoilMapping and then update it? > > Regards, > Dominic > > > -----Original Message----- > From: overture-bounce@xxxxxxxxxxxxx > [mailto:overture-bounce@xxxxxxxxxxxxx] On Behalf Of Bill Henshaw > Sent: Wednesday, January 30, 2008 12:22 PM > To: freelists > Subject: [overture] Re: Hyberbolic grid generation without Ogen > > Hi Dominic, > > The attached file contains the main program airfoil.C that shows > how to generate the naca airfoil grid with the hyperbolic grid > generator. I have also attached some new versions of Overture files > that you should use, replacing the ones you have. > > regards, > Bill. > > #DOMINIC DENVER JOHN CHANDAR# wrote: >> Hi, >> >> I'm trying to write up a small code to generate a a grid around an >> airfoil without ogen using the HyperbolicMapping class. I followed >> the > >> naca.hype.cmd ogen command file and i still think that i have missed >> some information in the code since i always end up in getting a >> negative volume error (Some problem in the T.E). But the >> naca.hype.cmd > >> works very well using ogen...(I've used similar parameters for both >> the cmd file and the source code). The code is as follows. Any ways >> to > >> rectify this error ?... Many thanks....Dominic >> >