I got the midi ports on the xs to be recognized in sonar, but now whenever I try and record or playback something, I get no metronome and nothing from the xs. As an example, when I try and change the patches to prepare the track for recording, the patches on the xs show up fine in Sonar, but whenever I arrow up and down, Sonar doesn't tell the xs to switch patches to match the patch selection. I might arrow to a trumpet patch but I still get a grand piano when I play the xs while I'm in the patch selection box. I downloaded sonar real producer 6, and I'm creating midi-only tracks, no audio. If I recall, the manual says something about turning off remote mode on the midi page under the utility menu? I haven't done that yet. However, doesn't the remote on/off button do the same thing? Jes ----- Original Message ----- From: Bryan Smart To: MoAccess@xxxxxxxxxxxxx Sent: Tuesday, October 16, 2007 1:31 AM Subject: Re: [MoAccess] Sonar not recognizing xs The MIDI ports for the Motif appear in Options|MIDI Devices. You must place checkmarks next to all of the Yamaha ports in order for them to show up as input and output choices on individual tracks. If the ports don't show up in MIDI Devices, then you didn't install the Motif USB drivers, or you didn't install the drivers for the MIDI interface where the Motif is attached. Bryan ------------------------------------------------------------------------------ From: moaccess-bounce@xxxxxxxxxxxxx [mailto:moaccess-bounce@xxxxxxxxxxxxx] On Behalf Of Jes Sent: Monday, October 15, 2007 10:53 PM To: MoAccess@xxxxxxxxxxxxx Subject: [MoAccess] Sonar not recognizing xs Hi. I downloaded a trial of sonar 6 producer or something like that, haven't used sonar in a long while. For some reason, the xs is not showing up as a midi controler for inputs and outputs. What should I do?