[PCB_FORUM] Re: thermal flash snafu
- From: "Gary MacIndoe" <gemcad@xxxxx>
- To: <icu-pcb-forum@xxxxxxxxxxxxx>
- Date: Thu, 8 Oct 2009 13:17:09 -0600
Thanks Jean-Charles, but I tried it that way and more. I think Barbara is on to
something with the flash_convert, just not sure exactly how to run it.
Regards,
Gary MacIndoe
gemcad@xxxxx<mailto:gemcad@xxxxx>
303-682-5230
----- Original Message -----
From: JCharles TEYSSIER<mailto:jeancharles.teyssier@xxxxxxx>
To: icu-pcb-forum@xxxxxxxxxxxxx<mailto:icu-pcb-forum@xxxxxxxxxxxxx>
Sent: Thursday, October 08, 2009 11:52 AM
Subject: [PCB_FORUM] Re: thermal flash snafu
Refresh padstack created with shapes is not easy.
- Refresh shapes
- Then refresh padsatck (do not refresh both at same time)
Sometimes it does the trick...
Jean-Charles
Gary MacIndoe a écrit :
Hey guys,
Ok, I've been creating Negative shapes for many years, and have been
banging my head over this one for hours, several times. It looks like the
thermal relief shapes are not being displayed correctly, or not found.
I am working on a design that was initially created by someone else, and my
DIMM symbol is not showing the thermal connections as it should (first screen
capture, BAD).
When I do a Tools -> Padstack -> Modify Design Padstack and edit the
padstack in the design, I can see that it is finding the thermal flash symbol.
My symbol is fine, as you can see as it is used in a similar design that I
created (second screen capture, GOOD).
I have looked everywhere I can think of to see if something is set wrong
with no luck. I have performed Update Symbols with everything checked with no
luck.
Any ideas?
Thanks for any help, it's driving me nuts (well, more nuts)!
BAD
GOOD
Regards,
Gary MacIndoe
gemcad@xxxxx<mailto:gemcad@xxxxx>
303-682-5230
Other related posts:
