Just left there in fact, saw one for about $21.00 that had three inputs. I need the amp however, I want to do more than two. Thanks -----Original Message----- From: ddots-l-bounce@xxxxxxxxxxxxx [mailto:ddots-l-bounce@xxxxxxxxxxxxx] On Behalf Of Gordon Kent Sent: Friday, May 27, 2005 4:33 PM To: ddots-l@xxxxxxxxxxxxx Subject: [ddots-l] Re: Recording with the monitors turned off. Jim: There are quite a few headphone amplifiers on the market if you want to connect a bunch of sets of phones. If you only need two, you could get a simple splitter at radio shack. Gord ----- Original Message ----- From: "Jim Jackson" <cs2005@xxxxxxxxx> To: <ddots-l@xxxxxxxxxxxxx> Sent: Friday, May 27, 2005 12:21 PM Subject: [ddots-l] Recording with the monitors turned off. Hello all, I'm planning a project which consists of more than one backup vocals, I want to record them all at once without using my audio monitors because of all the things that would feed in to the mics via the monitors. I assume that there would be something that I could buy that would plug in to my phone jack on my Mackie 12.02 mixer that would enable me to plug in multiple pairs of headsets. Can some one confirm this for me or suggest some other way of getting things done? Thanks ** To leave the list, click on the immediately-following link:- ** [mailto:ddots-l-request@xxxxxxxxxxxxx?subject=unsubscribe] ** If this link doesn't work then send a message to: ** ddots-l-request@xxxxxxxxxxxxx ** and in the Subject line type ** unsubscribe ** For other list commands such as vacation mode, click on the ** immediately-following link:- ** [mailto:ddots-l-request@xxxxxxxxxxxxx?subject=faq] ** or send a message, to ** ddots-l-request@xxxxxxxxxxxxx with the Subject:- faq ** To leave the list, click on the immediately-following link:- ** [mailto:ddots-l-request@xxxxxxxxxxxxx?subject=unsubscribe] ** If this link doesn't work then send a message to: ** ddots-l-request@xxxxxxxxxxxxx ** and in the Subject line type ** unsubscribe ** For other list commands such as vacation mode, click on the ** immediately-following link:- ** [mailto:ddots-l-request@xxxxxxxxxxxxx?subject=faq] ** or send a message, to ** ddots-l-request@xxxxxxxxxxxxx with the Subject:- faq ** To leave the list, click on the immediately-following link:- ** [mailto:ddots-l-request@xxxxxxxxxxxxx?subject=unsubscribe] ** If this link doesn't work then send a message to: ** ddots-l-request@xxxxxxxxxxxxx ** and in the Subject line type ** unsubscribe ** For other list commands such as vacation mode, click on the ** immediately-following link:- ** [mailto:ddots-l-request@xxxxxxxxxxxxx?subject=faq] ** or send a message, to ** ddots-l-request@xxxxxxxxxxxxx with the Subject:- faq