Check the vertical out for bad solder. The flash could have been a shorted CRT so Check the CRT. Usually if the transistor is shorted the CRT is shorted. Al Marquardt ampm@xxxxxxx Al Marquardt Electronic Repair 206 W Main Girardville Pa. 17935 ----- Original Message ----- From: "Warren" <warrenca@xxxxxxxxx> To: <techassist@xxxxxxxxxxxxx> Sent: Wednesday, April 06, 2005 8:35 AM Subject: [TechAssist] Zenith B25A11ZF Chassis 9-2108 Flat line then off. Won't start. > Hi All > > Just got started on this one. Wondering about the STR53041 if it's > good or not? > I have some saved STR53041's but I noticed that some of them have pins > 2-3 with a very low ohms. > I would like to hear from others if this indicates a bad chip.! > I need to throw these out if they are bad. > > BTW the customer said that the set flashed then went to a flat line , > then went out, and wouldn't go again. > At this early point I've only noticed one shorted transistor nearby the > regulator. Number escapes me right now at home. > > TIA > Warren Campbell > Campbell's TV & Appliances > Cannington ONT > ----------------------------------------------------------------------------- > This Email List is Public. Remove: http://www.tech-assist.org/remove.htm > Lost Password: http://www.tech-assist.org and select "Login Problems?". > Email Archives: //www.freelists.org/archives/techassist/ > ----------------------------------------------------------------------------- This Email List is Public. Remove: http://www.tech-assist.org/remove.htm Lost Password: http://www.tech-assist.org and select "Login Problems?". Email Archives: //www.freelists.org/archives/techassist/