Set came in dead . Repaired power supply and replaced HV splitter. Now have audio and faint screens on all tubes but no video. Is this a symptom of a bad focus block or something else? Video is present to crt pcb's. Screen voltage is present in the 200 volt range but i s loaded down by either scope or DVM measuement. Thanks, Don Busbin Electronics 113 South Main Street Fitzgerald, Ga. 31750 229-423-5665 ph/fax busbin@xxxxxxxxxxxxx ***************************************************************************** Classifieds! Buy or Sell! http://sell.tech-assist.org The Tech Address Book: http://www.tech-assist.org/secure/tip/contact.htm Add a Repair Tip Here, or Change/Remove your Email Address: http://www.tech-assist.org/secure/tip/main.htm Lost Password: http://www.tech-assist.org and select "Lost your Login Info?". Email Archives: //www.freelists.org/archives/techassist/