OEM splitter?? Check connection at input to splitter and did you install all the little rubber type gaskets onto the splitter wires?? Phillip R Hull STET phil245@xxxxxxxxxxxxx FAX 517--569-3075 ----- Original Message ----- From: "BUSBIN ELECTRONIC" <busbin@xxxxxxxxxxxxx> To: <techassist@xxxxxxxxxxxxx> Sent: Thursday, August 21, 2003 4:47 PM Subject: [TechAssist] RCA CTC169PE > Set came in dead . Repaired power supply and replaced HV splitter. > Now have audio and faint screens on all tubes but no video. > Is this a symptom of a bad focus block or something else? > Video is present to crt pcb's. Screen voltage is present in the 200 volt range but i s loaded down by either scope or DVM measuement. Thanks, Don > Busbin Electronics > 113 South Main Street > Fitzgerald, Ga. 31750 > 229-423-5665 ph/fax > busbin@xxxxxxxxxxxxx > **************************************************************************** * > Classifieds! Buy or Sell! > http://sell.tech-assist.org > The Tech Address Book: > http://www.tech-assist.org/secure/tip/contact.htm > Add a Repair Tip Here, or Change/Remove your Email Address: > http://www.tech-assist.org/secure/tip/main.htm > Lost Password: > http://www.tech-assist.org and select "Lost your Login Info?". > Email Archives: > //www.freelists.org/archives/techassist/ > > ***************************************************************************** Classifieds! Buy or Sell! http://sell.tech-assist.org The Tech Address Book: http://www.tech-assist.org/secure/tip/contact.htm Add a Repair Tip Here, or Change/Remove your Email Address: http://www.tech-assist.org/secure/tip/main.htm Lost Password: http://www.tech-assist.org and select "Lost your Login Info?". Email Archives: //www.freelists.org/archives/techassist/