What do you mean by "faint screens" ??? what happens when you increase the screen voltage? Just in case, check the wire from the HV splitter to the focus block, every once in a while you believe it is properlly inserted but it is not. Those focus blocks go bad sometimes, I have changed a few of them, but they were obviously cracked (they die by overheating) HTH Jorge At 04:47 p.m. 21/08/03 -0400, you wrote: >Set came in dead . Repaired power supply and replaced HV splitter. >Now have audio and faint screens on all tubes but no video. >Is this a symptom of a bad focus block or something else? >Video is present to crt pcb's. Screen voltage is present in the 200 volt >range but i s loaded down by either scope or DVM measuement. Thanks, Don >Busbin Electronics >113 South Main Street >Fitzgerald, Ga. 31750 >229-423-5665 ph/fax >busbin@xxxxxxxxxxxxx >***************************************************************************** >Classifieds! Buy or Sell! >http://sell.tech-assist.org >The Tech Address Book: >http://www.tech-assist.org/secure/tip/contact.htm >Add a Repair Tip Here, or Change/Remove your Email Address: >http://www.tech-assist.org/secure/tip/main.htm >Lost Password: >http://www.tech-assist.org and select "Lost your Login Info?". >Email Archives: >//www.freelists.org/archives/techassist/ Jorge Camboni, GY Electronics, Richardson, TX ***************************************************************************** Classifieds! Buy or Sell! http://sell.tech-assist.org The Tech Address Book: http://www.tech-assist.org/secure/tip/contact.htm Add a Repair Tip Here, or Change/Remove your Email Address: http://www.tech-assist.org/secure/tip/main.htm Lost Password: http://www.tech-assist.org and select "Lost your Login Info?". Email Archives: //www.freelists.org/archives/techassist/