Hi Don, I just did one like that. In mine, the scan loss circuit was activated. Check pin 6 of the 7 pin plug on one of the CRT boards. it should be 0V. I'll be it is higher. theat is the blanking line from the scan loss circuit. Good luck, John Myers Myers TV Service Co. Since 1984 Alliance, OH Voice: 330-821-6545 myerstv@xxxxxxxx http://members.ebay.com/aboutme/tvguy07/ http://members.ebay.com/aboutme/threads_r_us/ ----- Original Message ----- From: "BUSBIN ELECTRONIC" <busbin@xxxxxxxxxxxxx> To: <techassist@xxxxxxxxxxxxx> Sent: August 21, 2003 4:47 PM Subject: [TechAssist] RCA CTC169PE > Set came in dead . Repaired power supply and replaced HV splitter. > Now have audio and faint screens on all tubes but no video. > Is this a symptom of a bad focus block or something else? > Video is present to crt pcb's. Screen voltage is present in the 200 volt range but i s loaded down by either scope or DVM measuement. Thanks, Don > Busbin Electronics > 113 South Main Street > Fitzgerald, Ga. 31750 > 229-423-5665 ph/fax > busbin@xxxxxxxxxxxxx > **************************************************************************** * > Classifieds! Buy or Sell! > http://sell.tech-assist.org > The Tech Address Book: > http://www.tech-assist.org/secure/tip/contact.htm > Add a Repair Tip Here, or Change/Remove your Email Address: > http://www.tech-assist.org/secure/tip/main.htm > Lost Password: > http://www.tech-assist.org and select "Lost your Login Info?". > Email Archives: > //www.freelists.org/archives/techassist/ > > ***************************************************************************** Classifieds! Buy or Sell! http://sell.tech-assist.org The Tech Address Book: http://www.tech-assist.org/secure/tip/contact.htm Add a Repair Tip Here, or Change/Remove your Email Address: http://www.tech-assist.org/secure/tip/main.htm Lost Password: http://www.tech-assist.org and select "Lost your Login Info?". Email Archives: //www.freelists.org/archives/techassist/