Hi Carl a tip here check it out Eric RCA ITC008FCS SHUTS DOWN IMMEDIATELY AFTER TURN ON REPLACE TL062 Eric E M Electronics Deer Lake Nfld Canada tvman@xxxxxxxxxxxxxxx CARL HURT wrote: > I'm having problems with this chassis, It goes into shutdown in about a > second. > The shutdown leg of IC IV001 pin 36 EHT is 2.3 volts sams says it should be > 2.00 volts. it should take 3.6 volts to go into shutdown. > I assume it's not in overvoltage shutdown. > > I removed MAV board. still shutsdown. > > I'm Removing tuner tomorrow. > > The IPO30 regulator has all the correct voltages except pin 1 which is 11 > volts. This is high because of shutdown , I think. > > All power supply voltages are correct. > > I changed the eprom. > > Drive signal at Hor Driver transformer looks normal. > > All diodes in secondary of flyback look good. No shorts > > Any help or suggestions welcome. > > Carl Hurt Electronics > 3513 Budreau Av. > Savannah, Ga, 31408 > 912-964-2275 > churt-savannah@xxxxxxxxxxxxxxxx > > ----------------------------------------------------------------------------- > This Email List is Public. Remove: http://www.tech-assist.org/remove.htm > Lost Password: http://www.tech-assist.org and select "Login Problems?". > Appliance Repair List: http://www.tech-assist.org/secure/tip/chatjoin.htm#app > Email Archives: //www.freelists.org/archives/techassist/ > ----------------------------------------------------------------------------- This Email List is Public. Remove: http://www.tech-assist.org/remove.htm Lost Password: http://www.tech-assist.org and select "Login Problems?". Appliance Repair List: http://www.tech-assist.org/secure/tip/chatjoin.htm#app Email Archives: //www.freelists.org/archives/techassist/