I'm having problems with this chassis, It goes into shutdown in about a second. The shutdown leg of IC IV001 pin 36 EHT is 2.3 volts sams says it should be 2.00 volts. it should take 3.6 volts to go into shutdown. I assume it's not in overvoltage shutdown. I removed MAV board. still shutsdown. I'm Removing tuner tomorrow. The IPO30 regulator has all the correct voltages except pin 1 which is 11 volts. This is high because of shutdown , I think. All power supply voltages are correct. I changed the eprom. Drive signal at Hor Driver transformer looks normal. All diodes in secondary of flyback look good. No shorts Any help or suggestions welcome. Carl Hurt Electronics 3513 Budreau Av. Savannah, Ga, 31408 912-964-2275 churt-savannah@xxxxxxxxxxxxxxxx ----------------------------------------------------------------------------- This Email List is Public. Remove: http://www.tech-assist.org/remove.htm Lost Password: http://www.tech-assist.org and select "Login Problems?". Appliance Repair List: http://www.tech-assist.org/secure/tip/chatjoin.htm#app Email Archives: //www.freelists.org/archives/techassist/