Hi all! Not sure if you guys remember me. I was the one that screwed up his
tango trying to do a software restore. I've finally gotten around to doing
something about it, and on the new directions I have here it's asking for the
RestoreImageTango_WES.zip. DOES ANYONE HAVE THIS FILE!? Any help would be
greatly appreciated thank you!
Sent from my iPhone
On Sep 22, 2016, at 11:52 PM, Jan Willems <jwillems5@xxxxxxxxx> wrote:
Hey Lucas,
Thanks!
Are you running Logic X on El Capitan?
With a Tango 1? What consolesoft and firmware are you running on the Tango?
Are your sends working in Logic X with the Tango?
Thanks for the help!
Jan
Op donderdag 22 september 2016 heeft Ludger Mias <mias.l@xxxxxx> het volgende
geschreven:
Hi Jan,
glad you’ve got so much forward.
My Netsmart is 3.2.4.0. Yes, I think they are coming from the Netsmart
installer. Good luck.
Ludger
Am 19.09.2016 um 13:29 schrieb Jan Willems <jwillems5@xxxxxxxxx>:
Ludger Mias,
thanks for the 2 files (Logic Control.bundle and Logic Remote.bundle)
Where did you get these from? Are they coming from the Netsmart installer?
Which version of Netsmart is this?
Thanks for the help!
Jan
On Fri, Sep 16, 2016 at 4:41 PM, Ludger Mias <mias.l@xxxxxx> wrote:
Hi Jan,
enclosed find 2 files. Hope they will help you.
Best wishes, Ludger
Am 15.09.2016 um 23:56 schrieb Jan Willems <jwillems5@xxxxxxxxx>:
Hello All,
I have a Smart AV Tango 1 that i used for 3 years with Logic 9 on Snow
Leopard..
Now i have upgraded my computer to El Capitan with Logic X and i am
trying to get the Tango to work again!
I need to install the Smart AV Logic module (in Logic's control surfaces
setup window).
When i go to 'logic-preferences-control surfaces-setup-new-install' i
remember that the Smart AV control surface plugin was there when i did
it when i was in Snow Leopard, but now it's no more in the list (in both
logic 9 and logic X)..so i think a have to install this file manually..
I tried to go to the SmartAV website, but it's gone.. I have backups for
the consolesoftware and firmware and netsmart, so that's fine.. I am
looking only for the control surface plugin (the Smart AV Logic control
surface module) so i can install it for Logic 9 and logic X.
Also when i google it i can't seem to find anything..
I attached some screenshots to make it clear..
Can somebody help me with this?
Many thanks,
Jan Willems
<about control surface plugins.png><smart console control surface
plugin.png><smartAV support logic 9.png><smartAV support logic X.png>