Hi, 85 ohm will be not better for EMI pointiview. I prefer 100ohm impedance control on PCB. Thanks. Tesla At 2012-12-17 08:19:24,"miner_tom Cipollone" <tom_cip_11551@xxxxxxxxxxx> wrote: >I was told recently that in order to help reduce radiated emissions in HDMI >signals, routed from a PCB to an HDMI connector, that it was better to route >the signals at 85 Ohms differential as opposed to 100 Ohms differential. > > >The contention was that with added connector L/C the overall average impedance >normalized closer to 100 Ohms. > >Is there any credence to this? Is there any research material that agrees with >this? > > >(Hi Nazish) > >Thank You >Tom > > > > >------------------------------------------------------------------ >To unsubscribe from si-list: >si-list-request@xxxxxxxxxxxxx with 'unsubscribe' in the Subject field > >or to administer your membership from a web page, go to: >//www.freelists.org/webpage/si-list > >For help: >si-list-request@xxxxxxxxxxxxx with 'help' in the Subject field > > >List forum is accessible at: > http://tech.groups.yahoo.com/group/si-list > >List archives are viewable at: > //www.freelists.org/archives/si-list > >Old (prior to June 6, 2001) list archives are viewable at: > http://www.qsl.net/wb6tpu > > ------------------------------------------------------------------ To unsubscribe from si-list: si-list-request@xxxxxxxxxxxxx with 'unsubscribe' in the Subject field or to administer your membership from a web page, go to: //www.freelists.org/webpage/si-list For help: si-list-request@xxxxxxxxxxxxx with 'help' in the Subject field List forum is accessible at: http://tech.groups.yahoo.com/group/si-list List archives are viewable at: //www.freelists.org/archives/si-list Old (prior to June 6, 2001) list archives are viewable at: http://www.qsl.net/wb6tpu