Hi all, I need to calculate equivalent lumped capacitance seen by an IO driver which is connected to PCB trace (approx 3 Inches) and then cable. The average rise/fall time is 600ps. I have information about the PCB trace capacitance/inches. Will my assumption be correct if I take PCB-trace length (for lumped-capacitance calculation) which provides 300ps delay. What would be the best way to simulate IO driver as far as rise/fall time accuracy is concerned assuming lumped model for Tx line. Thanks sushil ==================================================== Beat indecision and you beat the clock. ------------------------------------------------------------------ To unsubscribe from si-list: si-list-request@xxxxxxxxxxxxx with 'unsubscribe' in the Subject field or to administer your membership from a web page, go to: //www.freelists.org/webpage/si-list For help: si-list-request@xxxxxxxxxxxxx with 'help' in the Subject field List FAQ wiki page is located at: http://si-list.org/wiki/wiki.pl?Si-List_FAQ List technical documents are available at: http://www.si-list.org List archives are viewable at: //www.freelists.org/archives/si-list or at our remote archives: http://groups.yahoo.com/group/si-list/messages Old (prior to June 6, 2001) list archives are viewable at: http://www.qsl.net/wb6tpu