Hello all,
What are your views on gnd pours in multi-layered PCBs (even on top/bottom),
assuming everything is stitched to lamda/8 or /10 etc.
I think it's better to have it as it would reduce the amount of etching the PCB
fab, and thus I'll get a board closer to what my given stackup. Furthermore,
in most cases the PCB adds copper balancing should I not add the pours.
I understand there could be risks of creating patch antennas, but would this
not be mitigated with stitching?
Kind regards,
--
Hakim Sellaoui
Hardware Engineer
DisplayLink (UK) Limited
Tel: +44 (0)1223 443920
DD: +44 (0)1223 443943
Fax: +44 (0)1223 443921
E: hakim.sellaoui@xxxxxxxxxxxxxxx<mailto:hakim.sellaoui@xxxxxxxxxxxxxxx>
W: http://www.displaylink.com/<http://www.displaylink.com/>
140 Science Park, Milton Road,
Cambridge, CB4 0GF,
United Kingdom.
Registered in England No. 04811048
DisplayLink Corp.
A US incorporated company.
480 S. California Avenue Ste 305, Palo Alto, CA 94306, USA.
------------------------------------------------------------------
To unsubscribe from si-list:
si-list-request@xxxxxxxxxxxxx with 'unsubscribe' in the Subject field
or to administer your membership from a web page, go to:
//www.freelists.org/webpage/si-list
For help:
si-list-request@xxxxxxxxxxxxx with 'help' in the Subject field
List forum is accessible at:
http://tech.groups.yahoo.com/group/si-list
List archives are viewable at:
//www.freelists.org/archives/si-list
Old (prior to June 6, 2001) list archives are viewable at:
http://www.qsl.net/wb6tpu