I have a problem.... I've always used FB papers but I thought that I would try using RC because I'm part of a print exchange. I thought that it would make the task of printing several prints, easier. WRONG Here's the situation: I used warm tone, VC peril RC I used a glass negative carrier to keep the negative flat because I knew the heat on the negative over an extended amount of time would cause it to flex. That was my first mistake. I cleaned the carrier but after the prints dried, there are a lot of tiny, tiny spots that I hadn't noticed when the print was wet. Before they had dried though, I sepia toned them and then selenium toned them. Washing in between, of course. Now I'm stuck trying to spot tone dual-toned prints on RC! grrrrrrrrrrr The RC isn't letting me spot them in the way that FB papers do. Also, I'm not sure that the sepia spot toner is the right color. HELP :) Becky Lynn ============================================================================================================= To unsubscribe from this list, go to www.freelists.org and logon to your account (the same e-mail address and password you set-up when you subscribed,) and unsubscribe from there.