[pure-silver] Re: Yellow colouration in C-41 negatives

  • From: "BOB KISS" <dmarc-noreply@xxxxxxxxxxxxx> ("bobkiss")
  • To: <pure-silver@xxxxxxxxxxxxx>
  • Date: Mon, 25 Oct 2021 10:15:22 -0400

DEAR RICHARD, 
            Perhaps I am missing something obvious but do I recall correctly 
that color C-41 negatives all have that yellowish/orange  cast to make printing 
easier, requiring less filtration?  Kodak referred to it as "the mask".  I only 
used C-41 black and white film once (because I hated the results) so I don't 
recall if it had the same overall cast.   
                                    CHEERS!
                                                BOB
 
-----Original Message-----
From: pure-silver-bounce@xxxxxxxxxxxxx 
[mailto:pure-silver-bounce@xxxxxxxxxxxxx] On Behalf Of `Richard Knoppow
Sent: Sunday, October 24, 2021 8:59 PM
To: pure-silver@xxxxxxxxxxxxx
Subject: [pure-silver] Re: Yellow colouration in C-41 negatives
 
   Is the yellow all over the negative, I mean up to the edges 
rather than just the image area? I am looking for clues. Can you 
tell if its on the emulsion side or the support side? The 
question is whether its actually some sort of flare. Old 
Kodachrome slides and prints often had a yellow color from the 
lacquer on them. Two kinds of lacquer, one came off with a mild 
alkaline solution like print developer, the other with a solvent 
but I don't remember what. I think that is unlikely here because 
it would be all over the film.
   Is this color or stain uniform?
 
On 10/24/2021 1:01 PM, Richard Urmonas wrote:

While not strictly silver I was hoping someone could shed some 
light on a yellow colouration on C-41 negatives.  I "inherited" 
the negatives from a family member so I do not know the history 
of development and storage, but expect these were processed by 
a local 1 hour lab and then stored in a drawer for a number of 
years.  From the contents I think these date from the 1990s.  
The issue I am observing is a yellow colouration across the 
whole frame, like a yellow filter was used.  This seems to have 
happened on random frames and can affect a single frame to 3 or 
4 in a row but then have "good" frames.  There is even a case 
where 2 frames apparently taken a short while apart have one 
with the yellow colouration and the other looking fine.  Note 
that the yellow colour is on the positive image from my 
scanner.  The colour shift can be seen on the negative.  This 
only affects some films, others which have been stored together 
with the affected films show no issue.  I would have suspected 
some colour fading effects, but this does not explain the whole 
frame being affected.  Can anyone shed some light on what might 
be going on?

Thank you,

Richard Urmonas


=============================================================================================================
 

To unsubscribe from this list, go to www.freelists.org and 
logon to your account (the same e-mail address and password you 
set-up when you subscribed,) and unsubscribe from there.
 
-- 
Richard Knoppow
dickburk@xxxxxxxxxxxxx
WB6KBL
 
=============================================================================================================
To unsubscribe from this list, go to www.freelists.org and logon to your 
account (the same e-mail address and password you set-up when you subscribed,) 
and unsubscribe from there.

Other related posts: