George Is the bar used during exposure of the mask? How do you re-align mask and neg after the development of the neg? How do you realign mask and neg the next time you want to print both? Regards Ralph W. Lambrecht http://www.darkroomagic.com On 2006-02-01 17:56, "Georges Giralt" <georges.giralt@xxxxxxx> wrote: > DarkroomMagic a écrit : >> Rob and all >> >> Thanks for the info. >> >> I must say, I find this not acceptable. A good system would allow for neg >> and mask to be aligned before mask exposure, separated for the development >> of the mask and realigned for print exposure. And all without tape! >> >> There is room for improvement here. >> >> Again thanks for the info, but I have a Mivalo for sale now! >> >> >> >> >> >> Regards >> >> >> >> Ralph W. Lambrecht >> >> http://www.darkroomagic.com > It is funny, because my Laborator 1000 which is the ancestor of the 1200 > use a special neg carrier for registration. This neg carrier hold a > removable plastic bar with 2 pins. > There is one bar for 4x5, one for 6x6 cm and (I may be wrong on this > one) one for 135 film. > Plus, the bar is located in an insert allowing you to expose the mask > outside of the enlarger, if one whish ... > So the system may be superior to the L1200 one... > Maybe there could be a special registration carrier for the 1200 ? ============================================================================================================To unsubscribe from this list, go to www.freelists.org and logon to your account (the same e-mail address and password you set-up when you subscribed,) and unsubscribe from there.