My bad, started thinking about what mode to use to connect to the server. For unconnected aprs we should use the default mode of the server. I understand that you are wondering, I seem to do so too hi hi. 73 de Per, sm0rwo tis 2010-01-05 klockan 10:08 +0100 skrev Pär Crusefalk: > mån 2010-01-04 klockan 18:59 -0500 skrev Greg: > > I've been somewhat following the new features involving auto mode > > selections. I wonder as far as just using the aprs feature to send pos > > reports, ping, etc. What mode do I send them? It used to be easy when > > everyone was psk250..now there is psk500 that can't be used here. Is it > > a matter of checking to see the server status page on the wiki? Is that > > all up to date now? Thanks for the help. - Greg > > > > Hi Greg, > > I guess there are two ways about this, you either use the default mode > of the server or you use the mode you think works best and make sure you > tx rsid. When the server receives the rsid it will switch to the mode > you have selected and ack your position. > > Regarding the wiki its a manual process of updating it so its up to the > server admins to make sure its correct. Perhaps we should have the > servers update a page automatically instead? > > Regarding psk500 I know you have restrictions, someone refered to it as > living in a "technology jail". But, PSK250 is good and PSK250R is > actually excellent. PSK500R has roughly the same throughput as PSK250 > and is very robust, it decodes with very little signal present. Since > switching to the robust modes the server hears traffic almost through > the night. > > 73 de Per, sm0rwo > > > >