Re: [PCWorks] Basic XP system and accessing the internet
- From: Peter Kaulback <peter@xxxxxxxxxxxxxxxxx>
- To: pcworks@xxxxxxxxxxxxx
- Date: Fri, 01 Aug 2008 15:15:18 -0400
Larry, I presume you already went through the setup for your card with
the Avermedia "Network Troubleshooting Guide"
http://www.avermedia.com/AVerDiGi/Upload/FAQ/Network%20Trouble%20Shooting%20Guide.pdf
or http://tinyurl.com/5elug4
Perhaps it may assist you.
Peter Kaulback
LarryB wrote:
> Peter, Thanks for the reply and I will get that info ASAP.
> I can't email from that computer so I usually copy to notepad and then
> put it on a stick.
> I have that SIW program so I'm sure I can find all that info.
> I also have not tried to open the router from that computer either so
> that will be something I will find out. I believe I changed the ports
> etc using my shop PC.
>
> Larry Browning
> Have a great day
>
>
> Peter Kaulback wrote:
>> What are your internet connection settings for TCP/IP? Can you open the
>> configuration application of the router from this pc? Can other pc's on
>> the network see this pc or ping it?
>>
>> Have you set all the security zones in IE to default levels?
>>
>> Are you using DNS or DDNS with your security system?
>>
>> Peter Kaulback
>>
>> LarryB wrote:
>>
>>> I have a NV3000 4 camera security system installed on a basic XP SP2 system.
>>>
>>> I am trying to access the Internet via the basic system to allow updates
>>> of the system XP not NV. (figure if I can do one I can do the other.)
>>>
>>> I have IE installed and I have the NV application enabled to allow
>>> "remote" viewing and control. I have to use a IP address to access this
>>> function. There is an application that is installed on the remote pc
>>> that connects to the IP address.
>>> If I just open a browser without using the application and put the
>>> address in directly, it will load software to allow viewing. (used to
>>> view from another location.)
>>>
>>> When I open IE on the PC it will not connect to allow browsing.
>>> My question is why? I should be able to connect to the M$ sites to
>>> update the software.
>>>
>>> This is co-located with my shop PC which connects just fine thru the
>>> bellsouth modem and my Linksys router using DSL.
>>> I have a cable from the security PC going direct to the router also and
>>> is a Cat 5 cable.
>>>
>>> I remember having to forward ports in the Linksys router to allow remote
>>> viewing and wonder if it might be as simple as changing some settings to
>>> allow internet access.
>>>
>>> I have put this on the CCTV forum and many have read it but no answers
>>> in several days. So thought I would try here.
>>>
>>> Thanks for your time.
=========================
The list's FAQ's can be seen by sending an email to
PCWorks-request@xxxxxxxxxxxxx with FAQ in the subject line.
To unsubscribe, subscribe, set Digest or Vacation to on or off, go to
//www.freelists.org/list/pcworks . You can also send an email to
PCWorks-request@xxxxxxxxxxxxx with Unsubscribe in the subject line. Your
member list settings can be found at
//www.freelists.org/cgi-bin/lsg2.cgi/l=pcworks . Once logged in, you have
access to numerous other email options.
The list archives are located at //www.freelists.org/archives/pcworks/ .
All email posted to the list will be placed there in the event anyone needs to
look for previous posts.
-zxdjhu-
Other related posts:
