Ismail, You're a genius! Ctrl+Shift+J has done the trick. I was under the impression that you had to have Alt within a short cut for it to work. Well done and many thanks. Jim -----Original Message----- From: jaws-uk-bounce@xxxxxxxxxxxxx [mailto:jaws-uk-bounce@xxxxxxxxxxxxx] On Behalf Of Ismail Sent: 20 February 2012 18:48 To: jaws-uk@xxxxxxxxxxxxx Subject: [jaws-uk] Re: Hot key for start up Hi Jim, I am not sure if a list of all the shortcut keys on your pc exists? I think a repair of jaws might be the best to see if the problem lies with jaws. As a matter of interest are you using alt control in the combinations you have tried? As a suggestion try shift control j to see if it works. Regards, Ismail ----- Original Message ----- From: "Jim Williams" <jwbr33694@xxxxxxxxxxxxxxxx> To: <jaws-uk@xxxxxxxxxxxxx> Sent: Monday, February 20, 2012 3:08 PM Subject: [jaws-uk] Re: Hot key for start up > Hi Ismail, > > I have been attempting to do as you say but each time I > reach number 5 in your list, immediately on pressing the > short cut key combination (and I have tried several > different combonations) I am taken back to the JAWS icon. I > press Alt+Tab to go back into Properties and the edit box > for the short cut key is empty again. > > I also think it might be because I am choosing a key > combination that is already being used but where is the list > of these short cut keys held so that I can check this theory > out. > > Jim > > -----Original Message----- > From: jaws-uk-bounce@xxxxxxxxxxxxx > [mailto:jaws-uk-bounce@xxxxxxxxxxxxx] On Behalf Of Ismail > Sent: 20 February 2012 10:50 > To: jaws-uk@xxxxxxxxxxxxx > Subject: [jaws-uk] Re: Hot key for start up > > Hi Jim, > > I have just tried setting up a jaws13 short cut key as > follows and have > tested it and it works fine. > 1. Find the jaws 13 icon on your desktop > 2. Press the context menu key (the key next to the control > key on the right > hand side) > 3. Cursor up and down to properties and hit enter. > 4. Tab to short cut key and delete anything that's there. > 5. Press the key combination you want to use and tab to > apply and hit space > bar. > 6. Tab through till you get to short cut key and make sure > jaws is > announcing your key combination then tab to OK and hit > enter. > > One of the reasons jaws would not let you set up a short cut > key is if that > short cut is being used somewhere else in another programme. > > Personally I would run a repair on jaws if this problem > continues and see if > that's solves the problem. > > Regards, > > Ismail. > > ----- Original Message ----- > From: "Jim Williams" <jwbr33694@xxxxxxxxxxxxxxxx> > To: <jaws-uk@xxxxxxxxxxxxx> > Sent: Monday, February 20, 2012 10:27 AM > Subject: [jaws-uk] Re: Hot key for start up > > >> Hi Mujtaba, >> >> Whatever key combination of keys I enter in the edit box I >> get dumped back at the JAWS icon without having a chance > to >> press the Apply or OK buttons. >> >> First of all, I deleted the short cut key combo I had for >> starting JAWS 9 (Alt+Ctrl+J) with the intention of using >> that for JAWS 13 but that wasn't accepted. As I mentioned > I >> tried several other combinations but without success. >> >> Can you remind me where the list of short cuts keys in use >> is kept within the JAWS menu system please. >> >> Jim >> >> -----Original Message----- >> From: jaws-uk-bounce@xxxxxxxxxxxxx >> [mailto:jaws-uk-bounce@xxxxxxxxxxxxx] On Behalf Of Mujtaba >> Merchant >> Sent: 14 February 2012 16:13 >> To: jaws-uk@xxxxxxxxxxxxx >> Subject: [jaws-uk] Re: Hot key for start up >> >> Hi Jim, >> Hit the start menu and then go to programs then scroll > down >> to the JAWS 13 program group sub menu, scroll down to > where >> it says JAWS and hit your application key on it. From the >> options there hit enter on create shortcut send to > desktop. >> Escape out of the menus and then go to the desktop and hit >> the J key till you hear JAWS. On this desktop icon hit the >> alt and enter key. This should open up a properties dialog >> box at the General page. Tab on this page till you hear >> Shortcut key and in the edit box of the same hit the keys >> you want as hotkeys to launch JAWS. After which tab to the >> apply button and hit enter. Then tab around and hit enter > on >> the OK button, this should close the properties dialog > box. >> Insert F4 to quit JAWS and try hitting the hot keys you >> specified to test if they work in launching JAWS. >> >> To disable JAWS from launching at startup go to the >> general/basics options for JAWS and uncheck the option > that >> says launch JAWS at startup. NOTE: You will have no > support >> from JAWS on your windows log on screen if you do this. >> >> Mujtaba Merchant >> Bangalore, India >> >> ----- Original Message ----- >> From: Jim Williams >> To: jaws-uk@xxxxxxxxxxxxx >> Sent: Tuesday, February 14, 2012 8:49 PM >> Subject: [jaws-uk] Hot key for start up >> >> >> Hi Folks, >> >> Using JAWS 13, XP Home and Office 2003 >> >> Can someone remind me of the key sequence for setting a > hot >> key for JAWS 13, rather than have JAWS start > automatically. >> >> Jim Williams >> >> ** To leave the list, click on the immediately-following >> link:- >> ** >> [mailto:jaws-uk-request@xxxxxxxxxxxxx?subject=unsubscribe] >> ** If this link doesn't work then send a message to: >> ** jaws-uk-request@xxxxxxxxxxxxx >> ** and in the Subject line type >> ** unsubscribe >> ** For other list commands such as vacation mode, click on >> the >> ** immediately-following link:- >> ** [mailto:jaws-uk-request@xxxxxxxxxxxxx?subjectúq] >> ** or send a message, to >> ** jaws-uk-request@xxxxxxxxxxxxx with the Subject:- faq >> >> ** To leave the list, click on the immediately-following >> link:- >> ** >> [mailto:jaws-uk-request@xxxxxxxxxxxxx?subject=unsubscribe] >> ** If this link doesn't work then send a message to: >> ** jaws-uk-request@xxxxxxxxxxxxx >> ** and in the Subject line type >> ** unsubscribe >> ** For other list commands such as vacation mode, click on >> the >> ** immediately-following link:- >> ** [mailto:jaws-uk-request@xxxxxxxxxxxxx?subject=faq] >> ** or send a message, to >> ** jaws-uk-request@xxxxxxxxxxxxx with the Subject:- faq >> >> ** To leave the list, click on the immediately-following > link:- >> ** > [mailto:jaws-uk-request@xxxxxxxxxxxxx?subject=unsubscribe] >> ** If this link doesn't work then send a message to: >> ** jaws-uk-request@xxxxxxxxxxxxx >> ** and in the Subject line type >> ** unsubscribe >> ** For other list commands such as vacation mode, click on > the >> ** immediately-following link:- >> ** [mailto:jaws-uk-request@xxxxxxxxxxxxx?subject=faq] >> ** or send a message, to >> ** jaws-uk-request@xxxxxxxxxxxxx with the Subject:- faq >> > > ** To leave the list, click on the immediately-following > link:- > ** > [mailto:jaws-uk-request@xxxxxxxxxxxxx?subject=unsubscribe] > ** If this link doesn't work then send a message to: > ** jaws-uk-request@xxxxxxxxxxxxx > ** and in the Subject line type > ** unsubscribe > ** For other list commands such as vacation mode, click on > the > ** immediately-following link:- > ** [mailto:jaws-uk-request@xxxxxxxxxxxxx?subject=faq] > ** or send a message, to > ** jaws-uk-request@xxxxxxxxxxxxx with the Subject:- faq > > ** To leave the list, click on the immediately-following link:- > ** [mailto:jaws-uk-request@xxxxxxxxxxxxx?subject=unsubscribe] > ** If this link doesn't work then send a message to: > ** jaws-uk-request@xxxxxxxxxxxxx > ** and in the Subject line type > ** unsubscribe > ** For other list commands such as vacation mode, click on the > ** immediately-following link:- > ** [mailto:jaws-uk-request@xxxxxxxxxxxxx?subject=faq] > ** or send a message, to > ** jaws-uk-request@xxxxxxxxxxxxx with the Subject:- faq > ** To leave the list, click on the immediately-following link:- ** [mailto:jaws-uk-request@xxxxxxxxxxxxx?subject=unsubscribe] ** If this link doesn't work then send a message to: ** jaws-uk-request@xxxxxxxxxxxxx ** and in the Subject line type ** unsubscribe ** For other list commands such as vacation mode, click on the ** immediately-following link:- ** [mailto:jaws-uk-request@xxxxxxxxxxxxx?subject=faq] ** or send a message, to ** jaws-uk-request@xxxxxxxxxxxxx with the Subject:- faq ** To leave the list, click on the immediately-following link:- ** [mailto:jaws-uk-request@xxxxxxxxxxxxx?subject=unsubscribe] ** If this link doesn't work then send a message to: ** jaws-uk-request@xxxxxxxxxxxxx ** and in the Subject line type ** unsubscribe ** For other list commands such as vacation mode, click on the ** immediately-following link:- ** [mailto:jaws-uk-request@xxxxxxxxxxxxx?subject=faq] ** or send a message, to ** jaws-uk-request@xxxxxxxxxxxxx with the Subject:- faq