[j-say list] Re: dragon 11.5
- From: "Brian Hartgen" <Brian.Hartgen@xxxxxxxxxxxxxxxxxxxxx>
- To: <j-say@xxxxxxxxxxxxx>
- Date: Fri, 23 Sep 2011 09:15:40 +0100
Hi Gary
Thanks for your message. A release of J-Say to coexist with Dragon 11.5
and JAWS 12 should be available by the end of this month.
We will let the list know when it is available!
Thanks for your interest.
From: j-say-bounce@xxxxxxxxxxxxx [mailto:j-say-bounce@xxxxxxxxxxxxx] On
Behalf Of Bornsen, Gary L.
Sent: 22 September 2011 22:06
To: j-say@xxxxxxxxxxxxx
Subject: [j-say list] dragon 11.5
Is j-say working with dragon 11.5? if not, any idea when it might be.
Thanks
gary
From: j-say-bounce@xxxxxxxxxxxxx [mailto:j-say-bounce@xxxxxxxxxxxxx] On
Behalf Of Ed. Rosenthal
Sent: Thursday, September 22, 2011 10:16 AM
To: j-say@xxxxxxxxxxxxx
Subject: [j-say list] Re: voice profile selection
I'm anticipating that from your description below you have multiple
users, and so when you start your J-Say installation (i.e. Dragon) it
announces that multiple users are available and you can use your up and
down arrows to make a selection.
If you only have one user then you will not hit the open user dialog box
and the user profile loads automatically.
However, if you need multiple users there is a way to set the Dragon
executable so that it would load just a specific user, avoiding the open
user dialog box. It's been a while since I needed to look this up, but
if you need it just post again and I'll do some research -ed.
Yours sincerely,
Edward S. Rosenthal
President and CEO
Next Generation Technologies, Inc. (NGT, Inc.)
20006 Cedar Valley Rd. #101
Lynnwood, Wa. 98036
425-744-1100 ext.15
EM: edward@xxxxxxxxxxxx
URL: http://www.ngtvoice.com
Skype: ed.rosenthal7
From: j-say-bounce@xxxxxxxxxxxxx [mailto:j-say-bounce@xxxxxxxxxxxxx] On
Behalf Of Martin, Sue W.
Sent: Thursday, September 22, 2011 7:45 AM
To: j-say@xxxxxxxxxxxxx
Subject: [j-say list] Re: voice profile selection
Hi Stuart,
There's no voice command to select a user profile because Dragon isn't
actually loaded ready to receive voice input at that point. It's only
ready to receive voice input after J-Say tells you that the computer is
ready for you to talk to it or, if you have sounds enabled, you hear the
chime sound.
Hope that helps.
From: j-say-bounce@xxxxxxxxxxxxx [mailto:j-say-bounce@xxxxxxxxxxxxx] On
Behalf Of Stuart Deadman
Sent: Thursday, September 22, 2011 9:27 AM
To: j-say@xxxxxxxxxxxxx
Subject: [j-say list] voice profile selection
High list,
is there a J say command to select the voice profile dialogue? I have
been searching through the documentation but can't find one. I didn't
know if I was missing something.
Thanks in advance
Stuart Deadman
stupotuk@xxxxxxxxxxx
Other related posts:
