Is j-say working with dragon 11.5? if not, any idea when it might be. Thanks gary From: j-say-bounce@xxxxxxxxxxxxx [mailto:j-say-bounce@xxxxxxxxxxxxx] On Behalf Of Ed. Rosenthal Sent: Thursday, September 22, 2011 10:16 AM To: j-say@xxxxxxxxxxxxx Subject: [j-say list] Re: voice profile selection I'm anticipating that from your description below you have multiple users, and so when you start your J-Say installation (i.e. Dragon) it announces that multiple users are available and you can use your up and down arrows to make a selection. If you only have one user then you will not hit the open user dialog box and the user profile loads automatically. However, if you need multiple users there is a way to set the Dragon executable so that it would load just a specific user, avoiding the open user dialog box. It's been a while since I needed to look this up, but if you need it just post again and I'll do some research -ed. Yours sincerely, Edward S. Rosenthal President and CEO Next Generation Technologies, Inc. (NGT, Inc.) 20006 Cedar Valley Rd. #101 Lynnwood, Wa. 98036 425-744-1100 ext.15 EM: edward@xxxxxxxxxxxx URL: http://www.ngtvoice.com Skype: ed.rosenthal7 From: j-say-bounce@xxxxxxxxxxxxx [mailto:j-say-bounce@xxxxxxxxxxxxx] On Behalf Of Martin, Sue W. Sent: Thursday, September 22, 2011 7:45 AM To: j-say@xxxxxxxxxxxxx Subject: [j-say list] Re: voice profile selection Hi Stuart, There's no voice command to select a user profile because Dragon isn't actually loaded ready to receive voice input at that point. It's only ready to receive voice input after J-Say tells you that the computer is ready for you to talk to it or, if you have sounds enabled, you hear the chime sound. Hope that helps. From: j-say-bounce@xxxxxxxxxxxxx<mailto:j-say-bounce@xxxxxxxxxxxxx> [mailto:j-say-bounce@xxxxxxxxxxxxx]<mailto:[mailto:j-say-bounce@xxxxxxxxxxxxx]> On Behalf Of Stuart Deadman Sent: Thursday, September 22, 2011 9:27 AM To: j-say@xxxxxxxxxxxxx<mailto:j-say@xxxxxxxxxxxxx> Subject: [j-say list] voice profile selection High list, is there a J say command to select the voice profile dialogue? I have been searching through the documentation but can't find one. I didn't know if I was missing something. Thanks in advance Stuart Deadman stupotuk@xxxxxxxxxxx<mailto:stupotuk@xxxxxxxxxxx>