The J-Say development to support Dragon 11.5 is in progress. It should not be long. I'm sure an announcement will go out to the list as soon as it's all spiffy and ready to go. From: j-say-bounce@xxxxxxxxxxxxx [mailto:j-say-bounce@xxxxxxxxxxxxx] On Behalf Of Bornsen, Gary L. Sent: Thursday, September 22, 2011 4:06 PM To: j-say@xxxxxxxxxxxxx Subject: [j-say list] dragon 11.5 Is j-say working with dragon 11.5? if not, any idea when it might be. Thanks gary From: j-say-bounce@xxxxxxxxxxxxx [mailto:j-say-bounce@xxxxxxxxxxxxx] On Behalf Of Ed. Rosenthal Sent: Thursday, September 22, 2011 10:16 AM To: j-say@xxxxxxxxxxxxx Subject: [j-say list] Re: voice profile selection I'm anticipating that from your description below you have multiple users, and so when you start your J-Say installation (i.e. Dragon) it announces that multiple users are available and you can use your up and down arrows to make a selection. If you only have one user then you will not hit the open user dialog box and the user profile loads automatically. However, if you need multiple users there is a way to set the Dragon executable so that it would load just a specific user, avoiding the open user dialog box. It's been a while since I needed to look this up, but if you need it just post again and I'll do some research -ed. Yours sincerely, Edward S. Rosenthal President and CEO Next Generation Technologies, Inc. (NGT, Inc.) 20006 Cedar Valley Rd. #101 Lynnwood, Wa. 98036 425-744-1100 ext.15 EM: edward@xxxxxxxxxxxx URL: http://www.ngtvoice.com Skype: ed.rosenthal7 From: j-say-bounce@xxxxxxxxxxxxx [mailto:j-say-bounce@xxxxxxxxxxxxx] On Behalf Of Martin, Sue W. Sent: Thursday, September 22, 2011 7:45 AM To: j-say@xxxxxxxxxxxxx Subject: [j-say list] Re: voice profile selection Hi Stuart, There's no voice command to select a user profile because Dragon isn't actually loaded ready to receive voice input at that point. It's only ready to receive voice input after J-Say tells you that the computer is ready for you to talk to it or, if you have sounds enabled, you hear the chime sound. Hope that helps. From: j-say-bounce@xxxxxxxxxxxxx [mailto:j-say-bounce@xxxxxxxxxxxxx] On Behalf Of Stuart Deadman Sent: Thursday, September 22, 2011 9:27 AM To: j-say@xxxxxxxxxxxxx Subject: [j-say list] voice profile selection High list, is there a J say command to select the voice profile dialogue? I have been searching through the documentation but can't find one. I didn't know if I was missing something. Thanks in advance Stuart Deadman stupotuk@xxxxxxxxxxx