Yes No_RAT property on your powers -----Original Message----- From: icu-pcb-forum-bounce@xxxxxxxxxxxxx [mailto:icu-pcb-forum-bounce@xxxxxxxxxxxxx] On Behalf Of Mark Salberg Sent: Tuesday, April 05, 2011 12:09 PM To: icu-pcb-forum@xxxxxxxxxxxxx Subject: [PCB_FORUM] Re: Very Slow Allegro v. 16.3 CM either up or not up didn't seem to make a difference. I will try the Pwr Rat. Do you mean NO_RAT property? Thanks, Mark On 4/5/2011 3:02 PM, Dickoff, Diane J wrote: > And don't have your constraint manager up. > > -----Original Message----- > From: icu-pcb-forum-bounce@xxxxxxxxxxxxx > [mailto:icu-pcb-forum-bounce@xxxxxxxxxxxxx] On Behalf Of Mark Salberg > Sent: Tuesday, April 05, 2011 11:57 AM > To: Cadence User Group > Subject: [PCB_FORUM] Very Slow Allegro v. 16.3 > > Hello, > I was wondering if anyone there would have any tricks to speed up Allegro. > I am editing a board with quite a few Constraints in the V.16.3 CM. > Whenever I slide a trace, move a via or any mod, it hangs up for 30 sec > each time. > I have tried changing global shapes params from smooth to rough and even > disabled. > Short of turning off On-Line DRC, which I do not want to do. > Many DRC's to clean up. > > > Mark > ----------------------------------------------------------- > To subscribe/unsubscribe: > Send a message to icu-pcb-forum-request@xxxxxxxxxxxxx > with a subject of subscribe or unsubscribe > > To view the archives of this list go to > //www.freelists.org/archives/icu-pcb-forum/ > > Problems or Questions: > Send an email to icu-pcb-forum-admins@xxxxxxxxxxxxx > ----------------------------------------------------------- > ----------------------------------------------------------- > To subscribe/unsubscribe: > Send a message to icu-pcb-forum-request@xxxxxxxxxxxxx > with a subject of subscribe or unsubscribe > > To view the archives of this list go to > //www.freelists.org/archives/icu-pcb-forum/ > > Problems or Questions: > Send an email to icu-pcb-forum-admins@xxxxxxxxxxxxx > ----------------------------------------------------------- ----------------------------------------------------------- To subscribe/unsubscribe: Send a message to icu-pcb-forum-request@xxxxxxxxxxxxx with a subject of subscribe or unsubscribe To view the archives of this list go to //www.freelists.org/archives/icu-pcb-forum/ Problems or Questions: Send an email to icu-pcb-forum-admins@xxxxxxxxxxxxx ----------------------------------------------------------- ----------------------------------------------------------- To subscribe/unsubscribe: Send a message to icu-pcb-forum-request@xxxxxxxxxxxxx with a subject of subscribe or unsubscribe To view the archives of this list go to //www.freelists.org/archives/icu-pcb-forum/ Problems or Questions: Send an email to icu-pcb-forum-admins@xxxxxxxxxxxxx -----------------------------------------------------------