[PCB_FORUM] Re: Very Slow Allegro v. 16.3

  • From: Frank <fxf@xxxxxxxxxxx>
  • To: "icu-pcb-forum@xxxxxxxxxxxxx" <icu-pcb-forum@xxxxxxxxxxxxx>
  • Date: Tue, 05 Apr 2011 17:31:35 -0400

Under Tools->Database Check  run the Performance Adviser and see what it says.

On 4/5/2011 3:19 PM, Dickoff, Diane J wrote:

Yes No_RAT property on your powers

-----Original Message-----
From: icu-pcb-forum-bounce@xxxxxxxxxxxxx 
[mailto:icu-pcb-forum-bounce@xxxxxxxxxxxxx] On Behalf Of Mark Salberg
Sent: Tuesday, April 05, 2011 12:09 PM
To: icu-pcb-forum@xxxxxxxxxxxxx
Subject: [PCB_FORUM] Re: Very Slow Allegro v. 16.3

CM either up or not up didn't seem to make a difference. I will try the
Pwr Rat.
Do you mean NO_RAT property?

Thanks,
Mark

On 4/5/2011 3:02 PM, Dickoff, Diane J wrote:

And don't have your constraint manager up.

-----Original Message-----
From: icu-pcb-forum-bounce@xxxxxxxxxxxxx 
[mailto:icu-pcb-forum-bounce@xxxxxxxxxxxxx] On Behalf Of Mark Salberg
Sent: Tuesday, April 05, 2011 11:57 AM
To: Cadence User Group
Subject: [PCB_FORUM] Very Slow Allegro v. 16.3

Hello,
I was wondering if anyone there would have any tricks to speed up Allegro.
I am editing a board with quite a few Constraints in the V.16.3 CM.
Whenever I slide a trace, move a via or any mod, it hangs up for 30 sec
each time.
I have tried changing global shapes params from smooth to rough and even
disabled.
Short of turning off On-Line DRC, which I do not want to do.
Many DRC's to clean up.


Mark

-----------------------------------------------------------
To subscribe/unsubscribe: Send a message to icu-pcb-forum-request@xxxxxxxxxxxxx 
with a subject of subscribe or unsubscribe

To view the archives of this list go to 
//www.freelists.org/archives/icu-pcb-forum/

Problems or Questions:
Send an email to icu-pcb-forum-admins@xxxxxxxxxxxxx
-----------------------------------------------------------

Other related posts:

  1. Home
  2. icu-pcb-forum
  3. Archive
  4. 04-2011