[PCB_FORUM] Very Slow Allegro v. 16.3
- From: Mark Salberg <msalberg@xxxxxxxxxxxx>
- To: Cadence User Group <icu-pcb-forum@xxxxxxxxxxxxx>
- Date: Tue, 05 Apr 2011 14:57:16 -0400
Hello,
I was wondering if anyone there would have any tricks to speed up Allegro.
I am editing a board with quite a few Constraints in the V.16.3 CM.
Whenever I slide a trace, move a via or any mod, it hangs up for 30 sec
each time.
I have tried changing global shapes params from smooth to rough and even
disabled.
Short of turning off On-Line DRC, which I do not want to do.
Many DRC's to clean up.
Mark
-----------------------------------------------------------
To subscribe/unsubscribe:
Send a message to icu-pcb-forum-request@xxxxxxxxxxxxx
with a subject of subscribe or unsubscribe
To view the archives of this list go to
//www.freelists.org/archives/icu-pcb-forum/
Problems or Questions:
Send an email to icu-pcb-forum-admins@xxxxxxxxxxxxx
-----------------------------------------------------------
Other related posts:
