I want to find another one, just in case, new or used. If I happen to find a new one, I'll install it and give you the used one for a pattern. There are several junk yards reasonably close to my neighborhood, so I'll go look. There is an independent parts store chain here that might have a new one on its shelves, so I'll try that too. On Sep 30, 2010, at 3:54 AM, John Christensen wrote: > I have had good luck with the 5 minute. I would do the same thing as you for > now. > > If we could find one, it could be cast in silver pretty easy. Silver is > cheaper to cast than brass, and can be soldered if need be. The plastic would > burn out just like one of my wax models. I could create it in CAD too, if I > had one to go by. I sent one to the junk yard with the old Monte..... I am > sure. Who knew? > JC > > On Wed, Sep 29, 2010 at 11:05 PM, Jared Ryan <jryan@xxxxxxxxxxxx> wrote: > One would think. It seems to be discontinued, and no online site lists it, > but like you said, it has to be on a shelf somewhere. I'm going to keep an > eye out. > > For now, since it's a clean break, I am putting it back together with > 30-minute epoxy, with a piece of brass shim material across the break for > reinforcement. I'm using the slow-cure epoxy so it should last (I don't > trust 5-minute for anything that's going to take much force). > > As the picture shows, the lever's pivot is "keyed," and getting it out is > just a matter of lining it up right and pulling it up. > > > On Sep 29, 2010, at 6:41 PM, Chris Lindh wrote: > > > I've bought from that guy before... > > > > I'd keep looking for a new replacement... I bet that Four Seasons part > > is on a shelf somewhere... > > > > Rules: Please play nicely with others. > > -List members page (text & pic links): > http://www.myelcamino.net/eclist.htm > -List members page (all pics): > http://www.myelcamino.net/ec_list.htm > >