That is the way I do it, but there always used to be the two brackets showing.
Now, jaws is only showing me a right bracket surrounded by blanks and the
process doesn't allow me to enter the code correctly, as reported to me by DBT
when I perform the task..
Ann Foxworth
-----Original Message-----
From: duxuser-bounce@xxxxxxxxxxxxx <duxuser-bounce@xxxxxxxxxxxxx> On Behalf Of
Roger Newell
Sent: Monday, October 1, 2018 6:26 PM
To: duxuser@xxxxxxxxxxxxx
Subject: [duxuser] Re: problems with DBT 12.3 and jaws
When you press CTRL+Left bracket, JAWS should say "Enter code and parameters.
Edit." You then type your code excluding the brackets and press Enter. Another
method to try to enter a code is to press F9.
On 10/2/18, Ann Foxworth <annfoxworth@xxxxxxxxxxxxx> wrote:
I'm running windows 10 on a laptop with jaws 18 and DBT 12.3. I had* * *
the same problem with 12.2 and 12.1 as well. When I type control plus
left bracket, the brackets are not on the screen for me to enter my
code between them. At least, if they show on the screen, jaws is not
announcing them. Where they should be, I'm finding blank spaces. If I
type in a code anyway, DBT says my codes were not entered properly.
Also, as I arrow down or right or left, every line is repeated by jaws
at least twice and sometime the cursor will not move at all. I checked
the view settings and both full page and print font are checked. I
tried to uncheck print font but there is apparently no way to perform
that action. Does anyone have any ideas what might be going on?
Ann Foxworth