I have a couple of these as spares & can verify that they are nice
parts. Tom put lots of effort into getting them built.They are surely
stronger & more fatigue/impact resistant than the original magnesium
parts.
For anyone concerned about dimensions, I quickly checked one that I
have. Overall height is 11 3/4 inches (tape measured), bearing bore
area is approx 1 7/8 inch diameter (rough cast surfaces).
Lee Johnson
Bobsy SR5-1
On 6/26/19, Tom Quaranto <tquan277@xxxxxxxxx> wrote:
Gents=========Thanks for being a subscriber to Bobsy Talk email. Be sure to also
The production run of these unobtainium pieces is now complete. These
uprites will fit most (if not all) SR-3 cars and up to the SR-6. They are
cast of 300 series aluminum and then hardened to T-6. The size is correct
and ready to machine for your brake caliper and stub axle bearing specs. No
more will be made, by me anyway.
I have 5 pieces left. The price is $950.00 USD each, plus shipping. Shipped
from 80422 postal code
Contact info:
Tom Quaranto
Tquan277@xxxxxxxxx
or via Bobsy talk
Best Regards
Tom
www.freelists.org/archive/bobsy_talk/. >>To unsubscribe to Bobsy Talk go toTo see an archive of past Bobsy Talk emails at