Doesn't X-Rite give support anymore?
Gesendet: Mittwoch, 20. Dezember 2017 um 00:54 Uhr
Von: "Roger Breton" <graxx@xxxxxxxxxxxx>
An: argyllcms@xxxxxxxxxxxxx
Betreff: [argyllcms] Re: DTP41 - is it useful?
Lars,
I have 5 DTP41s here, only one or two that are "useful", as far as
calibration is concerned.
Since these instruments have long been discontinued, it's impossible to have
them recalibrate.
And the "Calibration kit" is impossible to find.
MfG / Roger
-----Original Message-----
From: argyllcms-bounce@xxxxxxxxxxxxx [mailto:argyllcms-bounce@xxxxxxxxxxxxx]
On Behalf Of Lars-Daniel Weber
Sent: Tuesday, December 19, 2017 1:50 PM
To: argyllcms@xxxxxxxxxxxxx
Subject: [argyllcms] DTP41 - is it useful?
Hi there!
I've got an i1 Pro Rev. B, which got re-certificated two months ago.
My problem: I don't have a ruler and all the "hacks" with DIY aren't working
pretty good.
On eBay, you can find pretty cheap DTP41... are they useful for printer
profiling?
Sure, they need re-recertification, but that's easier to get than a
measurement ruler ;)
Best regards,
Lars-Daniel
