X-Rite stop DTP41 support 10 years ago :(
-----Original Message-----
From: argyllcms-bounce@xxxxxxxxxxxxx [mailto:argyllcms-bounce@xxxxxxxxxxxxx]
On Behalf Of Lars-Daniel Weber
Sent: Wednesday, December 20, 2017 11:18 AM
To: argyllcms@xxxxxxxxxxxxx
Subject: [argyllcms] Aw: Re: DTP41 - is it useful?
Doesn't X-Rite give support anymore?
Gesendet: Mittwoch, 20. Dezember 2017 um 00:54 Uhr
Von: "Roger Breton" <graxx@xxxxxxxxxxxx>
An: argyllcms@xxxxxxxxxxxxx
Betreff: [argyllcms] Re: DTP41 - is it useful?
Lars,
I have 5 DTP41s here, only one or two that are "useful", as far as
calibration is concerned.
Since these instruments have long been discontinued, it's impossible
to have them recalibrate.
And the "Calibration kit" is impossible to find.
MfG / Roger
-----Original Message-----
From: argyllcms-bounce@xxxxxxxxxxxxx
[mailto:argyllcms-bounce@xxxxxxxxxxxxx]
On Behalf Of Lars-Daniel Weber
Sent: Tuesday, December 19, 2017 1:50 PM
To: argyllcms@xxxxxxxxxxxxx
Subject: [argyllcms] DTP41 - is it useful?
Hi there!
I've got an i1 Pro Rev. B, which got re-certificated two months ago.
My problem: I don't have a ruler and all the "hacks" with DIY aren't
working pretty good.
On eBay, you can find pretty cheap DTP41... are they useful for
printer profiling?
Sure, they need re-recertification, but that's easier to get than a
measurement ruler ;)
Best regards,
Lars-Daniel
