Hi Vladimir, > Maybe it would be good if Fabricio could tell us for which printing technique > the profile will be prepared for. I was trying to create a profile starting from FOGRA39L with the purpose of limiting the TAC to 240% or less. This profile is intended to be tested in re-separating ads files before printing them on newspapers. > If it is for offset/weboffset printing, Than > I don't see the reason of limiting the TAC to 220% at the same time while > limiting the black down to 92%. > Even if you would manage to get smooth curves > with that setting, I rather would question the quality of your final print. > 220% is OK but IMHO the black should not be under 95%. No objections at all! I started with TAC 240% and 95% black, saw that playing with the total ink limit caused the curves to become rough at the edge and get curious... Fabrizio